Hi,
today I have finally finished succesfully (I hope) AOD rebuilt (after one year :smirk: ). I have all gears now, finally, but I still have troubles with high pressure. I have one idea where problem could be and I would like to know your opinion.
When I screw the blue highlighted bolt where it should be, the TV pressure reads about 25psi at idle. When I do unscrew it, the whole thing moves a little backward and the TV pressure reads about 0 psi at idle (both with the adjustment block set neutral position - no tension).
Now when I think about it I remeber that the green highlighted part WAS NOT inserted into the red notch (the whole cable is rotated cca 90 degrees to right) and I believe that could be the problem. Does any one have picture how it should look like? Is there some grommet on the green highlighted part which moves the whole think a little bit backward (in the direction of 0 psi)?
Thanks very much and please excuse my english, I am really tired and have no energy to think about grammar
today I have finally finished succesfully (I hope) AOD rebuilt (after one year :smirk: ). I have all gears now, finally, but I still have troubles with high pressure. I have one idea where problem could be and I would like to know your opinion.
When I screw the blue highlighted bolt where it should be, the TV pressure reads about 25psi at idle. When I do unscrew it, the whole thing moves a little backward and the TV pressure reads about 0 psi at idle (both with the adjustment block set neutral position - no tension).
Now when I think about it I remeber that the green highlighted part WAS NOT inserted into the red notch (the whole cable is rotated cca 90 degrees to right) and I believe that could be the problem. Does any one have picture how it should look like? Is there some grommet on the green highlighted part which moves the whole think a little bit backward (in the direction of 0 psi)?
Thanks very much and please excuse my english, I am really tired and have no energy to think about grammar
Comment