OK, This week at school i built new stronger upper control arm mounts.
Mainly because i broke one of the stock mounts off years ago. I welded it
back on but it was not right. It was kinda twisted. These new ones will not break .
Then i did some frame trimming just above the lower control arm.
to allow the car to sit lower with bigger tires . So now the lower control arms will
go inside the frame rails when lowered all the way. I also had to notch for the tie rod ends
:chainsaw:
Mainly because i broke one of the stock mounts off years ago. I welded it
back on but it was not right. It was kinda twisted. These new ones will not break .
Then i did some frame trimming just above the lower control arm.
to allow the car to sit lower with bigger tires . So now the lower control arms will
go inside the frame rails when lowered all the way. I also had to notch for the tie rod ends
:chainsaw:
Comment