If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Please let us know if things are working or not. This is still somewhat a work in progress so don't be too surprised if things magically appear from one visit to the next.
Our rear axle housing can not support 31 splines. Notice that in the pic of his 28 spline axles, the axle gets smaller at the spline part. That way the end bearings are the same on the 28 and 31 spline. But on our cars, the axle is the same small size all the way to the end. You do not have to up grade to 31 spline to get a stronger rear. All you need is some nice aftermarket 28 spline axles. Stock alxes doen't use the best metal. So getting upgraded 28 spline axles would be just as good if not better than going to stock 31 spline axles.
Are you sure? I remember reading Town Car Limos use 31-spline axles in their 8.8" rearends. 5.0L Mustang guys use 31-spline axles in their 8.8" rearends for dragstrip duty.
Yes, and requires a 31 spline axle housing. The axles in a Limo I have not factual info on that. But I would assume that it was a complete 31 spline axle housing. I got the chance to do a comparison of 2005 Mustang 31 spline axles next to my factory 28 splines. And aside from the length difference, the bearing end was larger than the 28s, so it would require a larger bearing housing than an old school 28.
I still think you are incorrect. My buddy removed his 28-spline 8.8" Ford rearend from his 5.0L Mustang. Sent it to a shop and they welded the tubes to the pumpkin, added 31-spline C-clip eliminator axles with four 5/8" wheel studs each, a Moser spool, 4.88 gears and an axle girdle.
I'm send my 8.8" rearend to this shop when I'm ready.
Go ahead, I hope yours works. But I am not guessing, or even going by a book. The 31 spline did not fit into my case. It would require a custom extra low profile axle bearing to work in my housing.
8.8 rear w/ Moser 33 spline, spool, & rear-end girdle
I dont see why they wouldnt fit.
I had to have the stock housings cut of & had welded on 9" axle housings on the ends of the tubes b/c the regular c-clip eliminators would not work with my rear end for some reason.
My rear-end is a mix of 8.8 & 9" parts all cut & welded to work together.
Listen GUY, you wanna get them go get them. He has 9" axle tubes! If they fit go ahead, but I told you my experience, they did not fit my axle tubes. Don't believe me then fine, I don't trust a lot of what I read on the web, but don't come back at me like a 5th grader "He's got em". try em, I hope they work, I really do. But I am 100% positive, that I can't put a 33 spline axle in mine. Maybe all it nees are thinner style bearings, maybe these are pretty common, I don't know. But they didn't fit mine the way it already is.
Comment