When I bought this thing, I did not bother to check the heater ... and of course it does not seem to work. The fan works somewhat, but no heat... normally I would think an open stuck thermostat, but since I have been randomly reading posts here it seems these cars have a vacuum operated contraption (that seems overly complex lol) that goes bad. What would be the first thing you would check?
I might need to make a run up to MI soon, so heat moved up on my list of priorities.
Thanks in advance
Eric
Announcement
Collapse
No announcement yet.
Eric's 1989 Yellow Grand Marquis
Collapse
X
-
Originally posted by jaywish View PostLike that "eye brow" roofline
Leave a comment:
-
Originally posted by slack View PostHave you checked out cold war motors on YouTube? He basically did a junk yard Kaiser restore. Really cool cars.
Leave a comment:
-
Originally posted by Eric62 View PostA little off topic here, but thinking ahead a few years, I'd like to put my Kaiser body on a panther chassis... have not measured anything yet, but it should work.
[ATTACH=CONFIG]51619[/ATTACH]
Leave a comment:
-
-
Finishing up the tranny pan, filter, and fluid job.
Also... a little worried about this at the bottom of my old pan, but was happy to find this:
" Ford uses it to plug the dipstick hole in the tranny before the dipstick gets installed. When the dipstick tube is installed, it falls on the bottom of the transmission pan. They all have one if the pan has never been off."
Other than that the pan had no sludge or metal of any kind in the pan... poured out the fluid and the pan looked like new. Going back out to try and drain the torque converter next.
Leave a comment:
-
I stopped on the slicktop conversion until my torch hoses come in. Once they do, I'll do some practice pieces first before doing it for real on the car.
Stopped at a junkyard, but they would not let me go in the yard, so I just left. The main thing I want is a seat and it's silly to mess with it unless I can go and check it out first. I did find a self serve about 20 miles away that I will go check out in the next few weeks.
Got the oil changed today... according to the old windshield sticker, I was only a few hundred miles over 3000. The oil wasn't honey colored, but it was no where near black either.
Started on the transmission fluid and pan swap today. The fluid is definitely not bright red, but it does not smell burnt at all. I also verified that the new pan bolts are correct. I will finish this up tomorrow.
Not much I know, but I'll get there.
I also got the maybe parts car towed yesterday... (dead electrical system) Not messing with it too much just yet, I did order the electrical and vacuum troubleshooting manual.
Leave a comment:
-
Originally posted by gadget73 View Posthonestly for small holes like that you could likely lead them shut instead of torch welding. Bit less heat and no grinding if you do it right.
Leave a comment:
-
honestly for small holes like that you could likely lead them shut instead of torch welding. Bit less heat and no grinding if you do it right.
Leave a comment:
-
Originally posted by Tiggie View PostConsidered buying a cheap MIG? They are easy to use and you stand a lot less chance of warping the metal.
Leave a comment:
-
Considered buying a cheap MIG? They are easy to use and you stand a lot less chance of warping the metal.
Leave a comment:
-
There are a bunch of brittle plastic clips, but mostly on the outside. Ford used the same clips on everything in the 80s, so the truck and Mustang market can usually yield up replacements if you need them. The interior clips are mostly just what hold on the door and some of the other panels on the side. They can be had too.
Leave a comment:
Leave a comment: