|
| GMN Chat Room | GMN's STORE!! | GMN's Gallery | Please!! |
sly
Beater gonna beat
Find latest postsMini Statistics
- Join Date
- 03-13-2010
- Last Activity
- Yesterday 07:35 PM
- Avatar
Join Groups 0 Permission Groups
sly is not a member of any public groups
- Tab Content
- sly's Activity
- Visitor Messages
- About Me
-
Older Activity
-
Yesterday, 04:05 PMBet the interior and bumpers have already been stripped.652 replies | 174431 view(s)
-
05-14-2022, 06:35 PMYou can use your current box. You may need the foam surround for the evap to wedge it into the hole properly. Retrofit kits are available at most...2 replies | 93 view(s)
-
05-13-2022, 02:47 PMYeah... the valve for the brake release is at the base of the steering shaft at the firewall and the line coming from the firewall off to the right...716 replies | 80884 view(s)
-
05-12-2022, 08:12 PMMost of the old stuff is through hole... so yeah... usually easy.25 replies | 1232 view(s)
-
05-12-2022, 08:09 PMAlso... AC flush is EXTREMELY EVIL STUFF AND WILL BURN YOU. Wear some severe chemical gloves. Nitrile gloves do absolutely NOTHING. Washing cuts in...66 replies | 10005 view(s)
-
05-12-2022, 08:05 PMEster oil for change over from R12 to R134a. It's compatible with both and won't cause acids to form. Change accumulator and o-tube, flush evap and...66 replies | 10005 view(s)
-
05-12-2022, 09:44 AMSounds like it. After getting the R12 system working, do remember to remove the R134a adapter. Hopefully it's one that doesn't require removing the...66 replies | 10005 view(s)
-
05-11-2022, 03:16 PMYou need a strap wrench to get that solenoid out. It's normal thread, but usually too damn tight to remove normally. Also need to clean every bit a...128 replies | 20348 view(s)
-
05-11-2022, 03:11 PMyeah... that bolt holding the pulley looks to be a little off perpendicular as well due to the warping of the plate. Might need to massage that back...716 replies | 80884 view(s)
-
05-11-2022, 10:50 AMThe plastic pulleys are actually not bad. Getting the original pully off is the hard part. Gotta pry the dust cap off (I used a dremel to grind the...716 replies | 80884 view(s)
-
05-11-2022, 10:46 AMIt's usually a small board wedged into the side of the cluster. No clue about the digital dashes though. But I've seen all of those issues on analog...25 replies | 1232 view(s)
-
05-10-2022, 05:08 PMYes... TV pressure is touchy AF. But once you get it set... you'll be good until the cable stretches or something comes loose.716 replies | 80884 view(s)
-
05-10-2022, 11:34 AMBackprobe the connector. Poke the probes along side the wire on the back side of the connector inside the rubber around the wires. Then you can check...25 replies | 1232 view(s)
-
05-09-2022, 11:49 PMHere's the RAS troubleshooting: http://www.grandmarq.net/sly/2002%20CV-MGM%20RAS%20Troubleshooting.pdf Here's the EVO troubleshooting:...128 replies | 20348 view(s)
-
05-09-2022, 11:33 PMThe module can be swapped out. That said... check the wiring to it first to make sure it's not just losing contact with power. Not sure on the...128 replies | 20348 view(s)
-
05-09-2022, 11:22 PMI'd trigger a relay with the stock horn circuit to drive all of that with a dedicated line from the battery just to cover it. Also... 20A should be...8 replies | 446 view(s)
-
05-09-2022, 11:07 PMThe set screw on the tip tends to back out and the cable slips causing you to lose the go pedal. Seems to be the most common issue with the Lokar...716 replies | 80884 view(s)
-
05-08-2022, 11:07 PMsly replied to a thread "Daily Subscription" is sending emails way too frequently. in GMN News/Site SuggestionsI can't find any options. Might be a bug in the system. It shouldn't email you without changes... but if they forum software creators didn't program...2 replies | 303 view(s)
-
05-06-2022, 11:53 AMI think energy suspension 4.3151G (black) or 4.3151R (red) is the one to use. IIRC, the control arms are the same up to 97 as far as bushing size...5 replies | 347 view(s)
-
05-06-2022, 11:40 AM:rtr:68 replies | 8465 view(s)
-
05-06-2022, 11:35 AMGetting there. Might be able to see the light at the end of the tunnel and it's not a train.59 replies | 5427 view(s)
6 Visitor Messages
About sly
Basic Information
- Age
- 44
About sly
- Biography:
- Shade tree mechanic, electronics engineer, and home PC nut.
- Location:
- Lewisville, TX
- Interests:
- Electronics, more power (vehicles), wife, computers, mods, wife (oh right)...
- Occupation:
- Failure Analyst (semiconductors aka chips)
Signature
Only two things are infinite, the universe and human stupidity, and I'm not sure about the former. -- Albert Einstein
rides: 93 Crown Vic LX (The Red Velvet Cake), 2000 Crown Vic base model (Sandy), 2003 Expedition (the vacation beast)
Originally Posted by gadget73
Originally Posted by dmccaig
Statistics
Total Posts
- Total Posts
- 22,968
- Posts Per Day
- 5.17
Visitor Messages
- Total Messages
- 6
- Most Recent Message
- 04-28-2016 12:34 AM
General Information
- Last Activity
- Yesterday 07:35 PM
- Join Date
- 03-13-2010
- Referrals
- 0
GMN Approved Links!
|
|