|
| GMN Chat Room | GMN's STORE!! | GMN's Gallery | Please!! |
Blazer
n00b
Find latest postsMini Statistics
- Join Date
- 05-24-2020
- Last Activity
- 02-09-2021 11:39 PM
- Avatar
More 3 Friends
More Albums
-
1996 Mercury Grand Marquis LS
05-29-2020
Recent Visitors
This page has had 1,821 visits
- Tab Content
- Blazer's Activity
- About Me
- Friends
-
Older Activity
-
Yesterday, 10:57 PMI think the impeller is a bit larger too. More water flow. run a tap in those extra holes if you don't have an iron pump now. Fair bet they...1 replies | 33 view(s) -
Yesterday, 08:51 PMgadget73 replied to a thread 1995 factory radio troubleshooting in Car Audio - Aftermarket and stockif you don't use the tape deck you can just unplug it. Its the wider connector. That will have the power and switching logic. The smaller one is...7 replies | 171 view(s)
-
Yesterday, 02:52 PMno, it just makes the core less likely to pop if you wind the engine up a bunch.9 replies | 75 view(s)
-
Yesterday, 01:27 PMI'm using a washer on mine. This is the official item https://lmr.com/item/LRS-18599A/79-04-Mustang-Heater-Core-Flow-Restrictor9 replies | 75 view(s)
-
04-15-2021, 08:49 PMred looks like trans fluid. Could be power steering since that also uses ATF. if it has a low oil level sensor on the side of the pan, that is...259 replies | 20683 view(s)
-
04-15-2021, 07:46 PMgadget73 replied to a thread 1995 factory radio troubleshooting in Car Audio - Aftermarket and stockyeah, switch in the tape mechanism. I don't happen to have one here to look at but somewhere in there there is a switch that is activated when the...7 replies | 171 view(s)
-
04-15-2021, 07:42 PMthere are still a few people around who know things, but less and less all the time I've got two vehicles with trans rebuilt by someone who knew...12 replies | 474 view(s)
-
04-15-2021, 07:35 PMexplorer covers are almost identical to stock lopo ones, except the fill neck is kind of goofy. I'd keep the original ones before swapping to...7 replies | 169 view(s)
-
04-15-2021, 07:33 PMgadget73 replied to a thread My 1987 Two Door Crown Victoria AKA THE BROWN BLOB in GMN Reader's Ridesprobably something with the audio compression. Tends to make things have a slightly nasal sort of sound.5042 replies | 790230 view(s)
-
04-14-2021, 11:21 PMprob have to be looking for stuff designed to fit under a stock EFI upper manifold. All of the carb ones are on the tall side. Cheapest option...7 replies | 169 view(s)
-
04-13-2021, 05:47 PMmy stuff tends to get changed by age more than mileage too. I think the oil in the Towncar is like 3 years old at this point but if its got a...259 replies | 20683 view(s)
-
04-13-2021, 05:46 PMthats a sad truth, the expertise is going away for a lot of this stuff. Lot of really bad trans shops out there too, I've ridden in some cars with...12 replies | 474 view(s)
-
04-13-2021, 05:44 PMkind of a bitch to change them. Only set I did with the LCA in I used a floor jack and a 2x6 on the pad to lift the engine by the front of the oil...101 replies | 4904 view(s)
-
04-12-2021, 09:44 PMhttps://www.facebook.com/marketplace/item/166234178700971/?ref=facebook_story_share Idk if it's real but anybody in Iowa? If I Had not just bought...92 replies | 5238 view(s) -
04-12-2021, 08:04 PMSounds odd and I have absolutely no idea if its anecdotal but when I did the pinion seal on the Conti I found that the pinion had no preload on it. ...101 replies | 4904 view(s)
-
04-12-2021, 07:57 PMgadget73 replied to a thread Re-pinning EEC connector for MSPNP2 for Foxbody? Also, wideband O2 wiring... in Electrical and wiring/HVAC/Vacuum/CFII'd move the thermactor wires or pull the solenoids out. Not sure if it will do anything funny if it sees voltage back on a pin that it isn't...7 replies | 143 view(s)
-
04-12-2021, 07:54 PMAnother AOD video from the same guy https://www.youtube.com/watch?v=lnidmkQ2-ds12 replies | 474 view(s)
-
04-12-2021, 02:36 PMwith a lot of this stuff I suspect that if you change it on some sort of reasonable interval, exactly what you change it with gets far less critical....259 replies | 20683 view(s)
-
04-12-2021, 02:31 PMgadget73 replied to a thread Lopo cam and ECU with heads + intake + headers? Is this doable, or disaster? in Box Panther Performancesomeone probably sells a universal fit harness for this kind of thing, but thats a bit like buying one size fits all underwear. Nothing is exactly...21 replies | 523 view(s)
-
04-12-2021, 02:28 PMgadget73 replied to a thread Re-pinning EEC connector for MSPNP2 for Foxbody? Also, wideband O2 wiring... in Electrical and wiring/HVAC/Vacuum/CFIgot the destructions handy? There are some small differences between the Fox pinout and the Panther. function color ...7 replies | 143 view(s)
-
04-12-2021, 09:10 AManother thought, did you have the fan off to do the shroud? If so, did it have a bushing inside the clutch that maybe got lost? The replacement...101 replies | 4904 view(s)
About Blazer
Basic Information
About Blazer
- Biography:
- Big fan of American 4 door sedans
- Location:
- The LBC
- Interests:
- Grand Marquis, Horses, Soccer
- Occupation:
- TV Producer
- Garage:
- 1996 MGM LS
- Where are we?:
- Grandmarq.net
Statistics
Total Posts
- Total Posts
- 2
- Posts Per Day
- 0.01
Albums
- Total Albums
- 1
- Total Photos
- 12
General Information
- Last Activity
- 02-09-2021 11:39 PM
- Join Date
- 05-24-2020
- Referrals
- 0
3 Friends
Showing Friends 1 to 3 of 3
GMN Approved Links!
|
|