You may have a bad dash switch.
![]() ![]() |
GMN Chat Room | GMN's STORE!! | GMN's Gallery | Please!! |
Type: Posts; User: Mainemantom; Keyword(s):
You may have a bad dash switch.
"That sticking issue sounds like the intermediate and possibly upper steering shafts are shot. The U-joints in the lower shaft get cooked from the exhaust manifold heat and bind up, which puts more...
That is why Ford made an extended version for taxis. Should have provided this option for civilian models.
COOL, Glad you bought it.
Nice looking low mileage CVPI. Picture of the rear bumper needs to be re- taken. Good price.
If anyone finds an extra factory option port/panel for an aero, please get it for me. It will be useful.
The best car covers I have found at a reasonable cost was sold on Ebay. It was advertised as having like 10 layers. Soft inside lining. Good for outside use. It is a heavy almost waterproof cover...
The seat back levers look to be more sturdy than the originals. Maybe they will not bend and break. I also like the center arm rest/console from a Lincoln. I wish I could find a maroon one.
Don't...
The knob below the power antenna switch is for the Premium Sound amp. I have on in my Mercury. Looks like the switch under the light switch was added on by owner.
If you can look at the vin number,...
I found your stainless trim for you. Part number EOAZ54291B20A
See Ebay listing #162202677470
Grand 1, you have a pm. I found another one from another vendor.
Wow, about double from what the car cost new. Very clean car especially the blue paint.
Carpet looks good. Did you have to do allot of trimming to make it fit ? Did you glue it down around the hump ?
I normally brace the hood open with a broomstick or prop rod. I do not trust the hood struts. I had the hood come down on me a couple of times. Yes it hurts !
Good job. I like the Ford bed liner. That was a good find. I had a similar camper shell with those type of locks on my 69 Dodge. I never had any problems when shell was locked. Hopefully you can...
Can't you keep the expired vehicles or parts vehicles covered up ? No logical complaint if the "violation" can't been seen. Another possibility would be put up a fence so no one can see behind it. ...
Very similar to my 83 MGM 2 door. Yours looks good. With gas prices as high as they are and increasing, many people will be ditching their large vehicles. Don't hold out too long to get the best...
I believe these to be the same design. Since they have not been used they would be better than the original. I can't be responsible for any mishaps. The alternator system needs to be replaced asap if...
I have new replacement pigtails available. They came with new/reman. alternators many years ago. Contact me if interested.
I agree with changing the alternator and wiring to 3G. Far better and...
These pages of wiring diagrams appear to show every wiring component, connector, pins, wires and colors. 17 big pages of valuable information. Pages are dated 1982. I remember these pages were not...
New old stock, plastic fuel line specifically for a Ford pickup. As per Ford, it was also used on 80s CV/MGM. 19 inches long. One end has a cap to protect the line, the other has a snap type...
I like that allot
In some areas of CA,(and other cities) that above mentioned artwork would be REAL and as common as traffic lights.
There used to be a Ford plant in South Central Los Angeles not too far from LAX. I don't know what year it closed. Maybe this was one of the last built there. The property sat vacant for many...
Did the stem with the crown pull out or just the crown come off ? If just the crown, it might screw on or is pressed on. Epoxy may work if it is pressed on. If the stem came out with the crown, I...
The seat belts look like center belts, might work for a sedan ?