Search:

Plastic gear on the transmission end can also cause bounce if it wears enough, the gear bounces around abit and gives you the wobble.

Nothing new around here that I've seen. If you are desperate give Coreys (here in London) a call about what they got. I don't go to them because they think everything is rare and expensive, but if...

My insurance company will consider your car an antique at 25yo for insurance purposes, which drops the insurance rates radically on that vehicle. But it can't be your primary vehicle, and you must...

The 2nd pic is yet another style of ranger cap if you didn't catch it, which corresponds to the ranger cap you linked.
The middle pic with the M is the oem ones, the next pic is an aftermarket set...

You could always use Ranger or mercury mountaineer center caps with the correct lug nuts. P71 center caps (pancake style) won't clear the front hubs.
First two pics are my box, I ran both ranger...

Power definately gets lower than the manual seat. Friend of mine had an 87 with manual seats vs my 89 with power.

Nice. =-) Around 1995 GM went to the metripak connectors and 2 wire connector showed up on the horns.

That '78 looks pretty decent for 2600 bucks. Its one of those if I had the space for another car I'd go look at it.

When all you have is a torch, hammer, 3/8" ratchet with a 6 inch extension... and need to reach the transmissions upper bolts...

Another possibility, "Hi Joes Autowrecking?" "Its Joe over at Joes fixit gerage, you got a box panther with good exhaust manifolds?" "Yeah Joe, only one though, a 91 town car, the manifolds will...

The trick is to take a short block of 2x4 and wedge it between the door pillar and the dash to get you the space you need. Face the plenum "down" and then rotate it back to proper orientation. It...

Bypassing all the wiring running back and forth to the headlight switch is a big improvement in itself. 6' of wire from the battery to relays & headlights vs 10'+ running to the headlight switch and...

Sometimes Monroe is the only thing we can get our hands on. And because of that you soon discover Monroes are not something you want anymore. At least if you get them warrantied you can flip them...

Do Champion plugs have a better reputation where you are? Cause you won't find anybody over on this side of the pond who will willingly run Champions in anything but a lawnmower. NGK's, Densos,...

I'm assuming that is an old photo. Remove the spout connector (the plug you remove when setting timing) and see what she does. It removes ecm control of the distributor if something is awry with it...

You got plenty of meat on those tires, depending on how many miles you put on it might be two years before you need to replace them. I run my rears down to the point I think a cop will take notice,...

Front late(r) model cop springs will raise the front. Moog 80090, 1998 crown vic police interceptor front springs.

Had a set on my MGM. Depending on what rear spring you have it may "over"...

Knock sensor (for 2008MY) is yellow-red & yellow.
Cylinder head temp is yellow-light green & grey-red.

The other two wire thing (besides injectors and coil plugs) is the heated pcv (which...

Based on the general motors truck, there is a roll pin that retains the handle. Gotta drive that out some, then the handle will pull free in some position; make note of the position the handle comes...

Looking through my 2008 evtm connector views, the only thing that comes close is the knock sensor connector and the cylinder head temp sensor connector, keying does not match. If they did replace...

Did you poke a wire into the holes and blow 'em out with air when you had it disassembled?
The other thing about little apparent change is its an emmisions era carb, ford probably did the same...

Got the spring/hanger thing on the needle hanging correctly on the float?

On A Qjet theres a right way and a wrong way, if its the wrong way you get a good chance of flooding it as the offset is...

If you look down the hole under the filter you will see a small drain, the windsheild water for the most water takes a side detour towards the fender where there is a channel to drain water. If you...

Contact cleaner/maf cleaner. You don't want any wd40 in there as that will get gummy from oxidation and you'll be doing this again sooner rather than later. Good oppertunity to put the override...

If I remember right, that vent should be sealed to the cowl to keep water from going in, originally its got some closed cell foam tape around the base. If you look down the hole, you will see your...