PotM GrandMarq.NET - Panther Headquarters Forum Index PotM
GMN Chat Room GMN's STORE!! GMN's Gallery Please!!

Search:

Type: Posts; User: gadget73; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.26 seconds.

  1. Replies
    112
    Views
    13,211

    full list of sensors that I can think of 2...

    full list of sensors that I can think of
    2 oxygen sensors
    ECT
    ACT
    coolant temp / idiot light
    oil pressure / idiot light
    EGR position (on the egr valve)
    distributor pickup

    thats really it....
  2. Replies
    8
    Views
    181

    Thinking its for the two line fuel pump. Not so...

    Thinking its for the two line fuel pump. Not so much a vapor line as the fuel return line. Those started to appear late in the carb era to deal with vapor lock problems. Keep the fuel moving...
  3. Replies
    8
    Views
    181

    1980 US Lincolns got EEC3 CFI with an in-tank...

    1980 US Lincolns got EEC3 CFI with an in-tank pump.

    Master parts manual says E0LY-9275B for 81-89 Ford/Mercury (Vic/GM) sedan 5.0 with EFI or CFI.
    80-89 Non-EFI with vapor return tube is...
  4. Replies
    26
    Views
    1,371

    Factory tanks were not painted. My rusty-ass car...

    Factory tanks were not painted. My rusty-ass car lost the original tank to a pinhole that rubbed through under the strap. It was not rusty anywhere, just dirty. Oil it if you're gonna do anything,...
  5. Replies
    348
    Views
    37,166

    toe slightly in makes the wheel center a little...

    toe slightly in makes the wheel center a little more, but makes it more dead in the middle. Toe out makes it more responsive but prone to drift and wander. Dead on zero is the worst of both, numb...
  6. Replies
    12
    Views
    293

    might also want to take note of what timing cover...

    might also want to take note of what timing cover is on that thing. There is a reverse flow pump one that doesn't work with the pump you need for stock belt setups.
    ...
  7. Replies
    17
    Views
    381

    can you see down into the valley under the...

    can you see down into the valley under the intake? There is a hose in there that can go and you won't see it until it fills the valley up with coolant and dumps out the back. Not familiar with the...
  8. Replies
    3
    Views
    162

    I use a plastic pry bar trim removal thing I got...

    I use a plastic pry bar trim removal thing I got from Harbor Freight, but I did still manage to slightly bend the trim on the Continental. Agree on it seeming a bit brutal to remove, but I guess...
  9. Replies
    12
    Views
    293

    Alt and PS bracket is the same, its the AC...

    Alt and PS bracket is the same, its the AC bracket that is specific for the 351. I think only one bolt gets used vs 2 though. Use the proper water pump for the engine, it all just fits together...
  10. Replies
    4
    Views
    132

    May as well. make sure you don't over-torque...

    May as well.

    make sure you don't over-torque the filter. I had problems with OD engagement on something and later info makes me think it was the filter bolt being too tight and causing the...
  11. Replies
    26
    Views
    1,371

    Wonder if vintage fuel has any value. Sell it to...

    Wonder if vintage fuel has any value. Sell it to the "retro everything" crowd. Genuine pre-COVID gasoline, low miles, second owner. No lowballers, I know what I have.
  12. Replies
    82
    Views
    6,317

    always thought those prancing moose emblems were...

    always thought those prancing moose emblems were funny but its even more appropriate on a red brick. The Saab troll stickers are also funny.
  13. Replies
    20
    Views
    1,367

    I'd honestly check the ground in the trunk first,...

    I'd honestly check the ground in the trunk first, probably the more accessible item. Also more likely to be at fault if the resistance directly at the sender reads normally.

    Might also have to...
  14. Replies
    3
    Views
    162

    there is a nut at the rear edge of the door, make...

    there is a nut at the rear edge of the door, make sure that is off. I think there is a screw up front too but its been a while since I had mine off. The keypad wire does need some slack in it, not...
  15. Replies
    4
    Views
    234

    I've never seen service docs for any of this...

    I've never seen service docs for any of this stuff. I guess that was all held secret. Radio service manuals exist so I'm assuming info for the other stuff existed somewhere but no idea where.

    ...
  16. Replies
    182
    Views
    47,860

    Sticky: The H pipe actually flows better than straight...

    The H pipe actually flows better than straight duals, makes more torque. personally I think it sounds better but thats entirely subjective.
  17. Replies
    182
    Views
    47,860

    Sticky: honestly there isn't much advantage to a better...

    honestly there isn't much advantage to a better intake on an otherwise stock motor. People have put Explorer intakes on and it lost low end torque without gaining much on the top end. The HO upper...
  18. Replies
    2
    Views
    135

    The buzzing noise? Thats the air suspension...

    The buzzing noise? Thats the air suspension compressor. The rubber mounts are probably bad, it should not be that loud.

    If you mean the "ting" noise when you let off the starter, that might just...
  19. Replies
    4,903
    Views
    681,432

    I'm kind of wheeling back towards stock or at...

    I'm kind of wheeling back towards stock or at least period-correct appearance myself. Anachronistic things look out of place.
  20. Replies
    11
    Views
    373

    The 100 amp is externally regulated and a larger...

    The 100 amp is externally regulated and a larger case, so it requires a lot of re-wiring and a different bracket to install one. Going the other way requires at least wire mods, there is a large...
  21. Replies
    707
    Views
    64,102

    closeness to the edge was my concern with the...

    closeness to the edge was my concern with the rivnuts. Don't want to drill through and find there isn't enough material for it to actually work. I have a slightly better tool to install them, but...
  22. Replies
    4
    Views
    234

    I'd wager on internal power supply issues. ...

    I'd wager on internal power supply issues. Probably the standard bad capacitors answer.
  23. Replies
    20
    Views
    1,367

    I put one of the trunk closers in my base model...

    I put one of the trunk closers in my base model that didn't come with it. Its entirely a "oooh, lookie at the fancy car" thing. Functionally the latch I removed is probably a better idea.

    make...
  24. Replies
    707
    Views
    64,102

    those lower shock mounts are not very good. Mine...

    those lower shock mounts are not very good. Mine stripped out a long time ago. I have some crappy speed nuts in there holding it together but at some point in the future I really should come up with...
  25. Replies
    8
    Views
    290

    ever checked the fuel filter? Might have sucked...

    ever checked the fuel filter? Might have sucked up some trash and plugged the filter.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4
GMN Approved Links!


www.rockauto.com www.adtr.net