PotM GrandMarq.NET - Panther Headquarters Forum Index PotM
GMN Chat Room GMN's STORE!! GMN's Gallery Please!!

Search:

Type: Posts; User: GMP318; Keyword(s):

Search: Search took 0.00 seconds.

  1. Replies
    4
    Views
    443

    Thanks for the reply. So, the boot is mounted on...

    Thanks for the reply. So, the boot is mounted on the underside of the control arm, which is correct , right? Of course the nuts and bolts are holding everything on.
  2. Replies
    4
    Views
    443

    Ball joint question. 1991 Crown Vic.

    Hello,

    Replacing the ball joints. Had a question on the installing the uppers. The uppers have a separate rubber boot that is bonded on a flat piece of metal with screw holes. When installing...
  3. Update: Yesterday after I swapped out pcms I...

    Update: Yesterday after I swapped out pcms I reported back that I was still having the same issue with the fuel pump continuously running. Well, later on that day I started the engine. Shut it...
  4. Hello, Thanks for the input. Where would...

    Hello,

    Thanks for the input. Where would the ecm ground be located? The pcm does slide into metal slider, so in theory the pcm case should be grounded to that.
  5. Put in the other pcm and still have the same...

    Put in the other pcm and still have the same problem with the fuel pump staying on. I'm thinking it's a fuel related issue where the fuel pump is losing its prime when the car sits overnight.
    ...
  6. Hello, Here is an update. Still have the...

    Hello,

    Here is an update. Still have the problem with the fuel pump staying on. Sometimes stays on for 6 seconds, sometimes it's a minute or to with the key in the on position.
    However ,...
  7. Replies
    6
    Views
    1,439

    test

    test
  8. Replies
    6
    Views
    1,439

    I didn't have it shipped. I drove up with a...

    I didn't have it shipped. I drove up with a trailer to pick up the trunk lid. This is in Florida. Drove 4 or 5 hours to a Dade City salvage yard.
    For shipping check RL, Gator, Yellow websites...
  9. Replies
    6
    Views
    1,439

    Ye. Definetly car-part. That's how I found my...

    Ye. Definetly car-part. That's how I found my trunk lid for my 91 crown vic. When you contact the salvage yard that has the part you need make sure you request pics.
  10. The PIP was replaced too. I replaced that a few...

    The PIP was replaced too. I replaced that a few years ago. I have spark going to all of the cylinders.
  11. My bad for not replying. Yes I did replace the...

    My bad for not replying. Yes I did replace the TFI module.
  12. Replies
    12
    Views
    1,371

    "Having tried an 07 system under my 97,...

    "Having tried an 07 system under my 97, everything seems off. The H-Pipe hit the floorboard and the over axle section seemed way tighter. Id consider the earlier system to be closer related to...
  13. Thread: Codes

    by GMP318
    Replies
    16
    Views
    1,321

    The codes 41 and 91 could be injectors. If...

    The codes 41 and 91 could be injectors. If you've done everything else and still have the codes 41 and 91 then check the injectors. They may not be shooting fuel directly into the intake valve. ...
  14. Replies
    26
    Views
    2,555

    Congratulations on your acquisition. These cars...

    Congratulations on your acquisition. These cars are very easy to work on. You should do the work yourself; at least, the tune up. Idling too high is an indication of a vacuum leak.
  15. Sly: "If it fires up after sitting for several...

    Sly: "If it fires up after sitting for several hours, but not after sitting for less than an hour, I would place my bets on heat issue with the TFI module."


    In reply to the previous post. The...
  16. Hello. This morning went to start the car up. ...

    Hello. This morning went to start the car up. Car sat overnight for about 10 hours. Key on, fuel pump primed then stopped. Priming this time, took 3 - 4 seconds. Car started right up.
    If the...
  17. Update: Went to start the car this morning. The...

    Update: Went to start the car this morning. The fuel pump stayed running. While I had the fuel pump running I pulled out the fuel pump relay and it shut it off. Put the relay back in, put key to...
  18. Thank you gadget73. Problem fixed. Crown...

    Thank you gadget73. Problem fixed. Crown Vic running. Problem was with the TFI module. You were right . Looks like it was a flakey or messed up PIP signal going to the ecm.
    Also, maybe...
  19. 91 Ford Crown Vic, no start condition, fuel pump stays running.

    I have a no start condition on my 91 Ford Crown Vic.
    When I turn ignition key to on position the fuel pump runs but does not shut off. Before, when the ignition switch is in the on position, the...
  20. Looking for this latch from 83-91 Grand Marquis or Ford Crown Vic. Please see pic.

    Hello,

    Looking for this slider latch. Part is the same on 83-91 Grand Marquis and Ford Crown Vic.. Thanks.
    ...
  21. Replies
    16
    Views
    1,199

    Hello from George in Pembroke Pines, FL

    I,m happy to be on this message board. I have a 1991 Ford Crown Victoria with the P72 police package. Looking forward to corresponding with other panther body owners.
  22. Welcome everyone. I live down in south Florida....

    Welcome everyone. I live down in south Florida. The city is Pembroke Pines.
  23. Looking for trunk lid for 88-91 Ford Crown Vic

    Looking for trunk lid for a 1991 Ford Crown Vic.
  24. Thread: Test

    by GMP318
    Replies
    1
    Views
    933

    Test

    Test
  25. How is the trunk lid? I am looking for a good...

    How is the trunk lid? I am looking for a good used trunk lid for my 91 Crown Vic. Any dents or rust/rot on the trunk lid ?
    How is the bottom part where the chrome moulding goes on? Any rust on...
Results 1 to 25 of 25
GMN Approved Links!


www.rockauto.com www.adtr.net