PotM GrandMarq.NET - Panther Headquarters Forum Index PotM
GMN Chat Room GMN's STORE!! GMN's Gallery Please!!

Search:

Type: Posts; User: sly; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.14 seconds.

  1. Thread: King ranch seats

    by sly
    Replies
    4
    Views
    123

    If the controls are on the seat already, it'll be...

    If the controls are on the seat already, it'll be cake. Just bolt in, power up (2 wires) and done.

    If the controls are on the door... then it's wiring diagram patchwork.
  2. Replies
    7
    Views
    124

    Loose chain will lead to misfires and random...

    Loose chain will lead to misfires and random stumbles. If it's bad and starts jumping, you could bend valves if it jumps too far. And if it's up to an 87? maybe 88? (some random cars up to 88 I've...
  3. Thread: Lmr 130 amp kit

    by sly
    Replies
    13
    Views
    302

    I put a ministarter on the 88 MGM I had when that...

    I put a ministarter on the 88 MGM I had when that starter died. Just a parts store special for a 91.
  4. Sticky: Conditioning portion of the circuit isn't needed....

    Conditioning portion of the circuit isn't needed. In fact, it failed on my car and prevented the tach from getting a signal. Now I have raw signal coming from the diode array. I also seem to have...
  5. Replies
    73
    Views
    2,898

    Diag port is in the trunk on the passenger side,...

    Diag port is in the trunk on the passenger side, above where the jack should be in the side saddle area, but I don't think an OBD1 code reader will work with that port.
  6. Replies
    114
    Views
    4,111

    Shims were included with the one I ordered when I...

    Shims were included with the one I ordered when I replaced the ac clutch on the Mad Marquis.

    I did have to use those plus one of the old ones from the old clutch though.
  7. Replies
    114
    Views
    4,111

    If you have power at the compressor clutch and no...

    If you have power at the compressor clutch and no clutch engagement, You can just replace the clutch and it should work then. I've had a clutch die on me as well. You will need some C-clip pliers...
  8. Replies
    11
    Views
    246

    I ran 2 10s in the trunk of mine to overpower the...

    I ran 2 10s in the trunk of mine to overpower the rear seat insulation. In my 93 I cut out the "subwoofer hole" part of the cardboard of the rear deck carpet and back-filled it with a metal speaker...
  9. Thread: 02 MGM Help needed

    by sly
    Replies
    32
    Views
    1,111

    oh yeah... that cat was dead. As for a torque...

    oh yeah... that cat was dead. As for a torque value... I've never checked. Always just rammed it home with my 120v 1/2 impact (does about 85-100 ft-lbs). I figure tight is good.
  10. Thread: vacuum lines

    by sly
    Replies
    4
    Views
    133

    I think he means the skinny HVAC vacuum line from...

    I think he means the skinny HVAC vacuum line from the soup can... it's that slick-ish skinny stuff. Just get some regular vacuum hose, cut the line where the hole is and push it inside the regular...
  11. Replies
    7
    Views
    298

    Moved to general since you were asking about the...

    Moved to general since you were asking about the condition of the car.
  12. The difference side to side may be a channel...

    The difference side to side may be a channel going out in the amp. When I originally got the Mark VI I ended up selling to sxcpotatoes, it had the front right channel dead on the premium sound. It...
  13. Thread: Oversized radiator

    by sly
    Replies
    30
    Views
    1,527

    If the water looks like it has rust flakes in it,...

    If the water looks like it has rust flakes in it, I would suggest hosing out everything until it runs clear (including the heater core) and then maybe think about a coolant filter to keep the heater...
  14. Replies
    8
    Views
    250

    Whale 8.8, 98+, uses a watts link for centering...

    Whale 8.8, 98+, uses a watts link for centering and almost parallel control arms at the ends instead of the 4-link binding control arms boxes and aeros have.
  15. Replies
    8
    Views
    209

    yeah... 31 spline was 05+ only. special order...

    yeah... 31 spline was 05+ only. special order from Moser will get you 31 spline though. The 8.8 can handle the power, though a few mods are worth the time... welding the tubes to the pumpkin, diff...
  16. Replies
    2
    Views
    157

    The plastic gears are the same. The difference...

    The plastic gears are the same. The difference comes with the digit assembly gears or the input gear from the cable in the speedo head (can't remember which - probably the input gear). Also the...
  17. Thread: 02 MGM Help needed

    by sly
    Replies
    32
    Views
    1,111

    I want to say bank 2 is driver side because...

    I want to say bank 2 is driver side because cylinder 1 is passenger side... but I may be wrong. As for the bolts... soak them with penetrating lube. Let it sit a while... soak again... repeat. And...
  18. Thread: Rims

    by sly
    Replies
    10
    Views
    275

    Something to keep an eye out for would be a set...

    Something to keep an eye out for would be a set of these popping up in the usual places if you like the wide spoke design (instead of the Y spoke like you have now):...
  19. Considering the heater core is like $30 or so......

    Considering the heater core is like $30 or so... I'd do it and keep the old one as a spare.
  20. Thread: Rims

    by sly
    Replies
    10
    Views
    275

    Which MGM wheels do you have on it now? There are...

    Which MGM wheels do you have on it now? There are several different styles from 03-11 that will fit fine (though not having them on hand will of course raise the price of things as you'd have to...
  21. Replies
    9
    Views
    263

    +1 it's plastic... no torch. Heat gun only on low...

    +1 it's plastic... no torch. Heat gun only on low at at least 6+ inches distance. Just want to get it pliable and not soft.
  22. Thread: Floor mats for Box

    by sly
    Replies
    8
    Views
    281

    I had the Weathertech knock-offs from Walmart in...

    I had the Weathertech knock-offs from Walmart in the Mad Marquis. Years of abuse and still in top shape when I sold the car. Nice deep pattern for catching crap. Worked great and were only $20 at the...
  23. I know when I had a bad ECT, cold starts were...

    I know when I had a bad ECT, cold starts were fine, but hot starts and operating temp were a real battle to do anything. My ECT failed resistive and the computer thought it was 60F at all times....
  24. Thread: 02 MGM Help needed

    by sly
    Replies
    32
    Views
    1,111

    Here's hoping that was it.

    Here's hoping that was it.
  25. Thread: 02 MGM Help needed

    by sly
    Replies
    32
    Views
    1,111

    If the fuel filter hasn't been recently...

    If the fuel filter hasn't been recently changed... might be something to think about too.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4
GMN Approved Links!


www.rockauto.com www.adtr.net