PotM GrandMarq.NET - Panther Headquarters Forum Index PotM
GMN Chat Room GMN's STORE!! GMN's Gallery Please!!

Search:

Type: Posts; User: 86VickyLX; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.12 seconds.

  1. Replies
    6
    Views
    218

    Convert it. easy peasy

    Convert it. easy peasy
  2. Replies
    3
    Views
    128

    Basically, just go by whatever Ford used on the...

    Basically, just go by whatever Ford used on the later vehicles. The fuel pump power wire gets a 20 amp fuse. The EEC power relay gets 30 amps. The rear defroster grid gets a 40 amp fuse. Ideally if...
  3. Replies
    65
    Views
    3,945

    That was one other thing I was concerned about....

    That was one other thing I was concerned about. It was a tight fit as it was.
  4. Replies
    65
    Views
    3,945

    Simple. Tall valve covers don't allow upper...

    Simple. Tall valve covers don't allow upper intake to clear without a spacer. Any more height and I was definitely running into issues. The Lightning/tubular upper is the lowest profile and the...
  5. Replies
    65
    Views
    3,945

    Picture Dump

    Engine in. Then a shot of the tailpipes. Police rear sway bar installed. And a shot of the tripminder going on a trip to the Pumpkin Run back in November.
  6. Replies
    65
    Views
    3,945

    Picture Dump

    Engine out. Engine in, radiator installed.
  7. Replies
    65
    Views
    3,945

    Picture Dump

    In this collection. You'll see the rear from Blue, derusted and painted. Also the big brake swap pieces from Blue also derusted and painted. Or at least one side. This happened over a few days of...
  8. Replies
    65
    Views
    3,945

    Picture Dump

    You can see I finally got my head out of my ass and installed the Powered By Ford valve covers, and swapped over to the 39lb fuel injectors. At this point the engine is ready for install. Also...
  9. Replies
    65
    Views
    3,945

    Picture Dump

    More photos. I was playing around with other valve covers which proved to be too stupidly tall to be used in order for my hood to clear. You can also see mock up of 3g alternator case, and the...
  10. Replies
    65
    Views
    3,945

    Picture Dump

    5348953497534965349553494
  11. Replies
    65
    Views
    3,945

    Picture Dump

    Here's the first photo dump of engine pics. Rotating assembly installed by machine shop. I painted the block and assembled the rest of the engine. More pictures to follow.
  12. Replies
    65
    Views
    3,945

    I'm not so good with responding on here. Only...

    I'm not so good with responding on here. Only reason I saw it was due to email updates from this thread haha.
  13. Replies
    65
    Views
    3,945

    No I didn't have to cut the hood for the...

    No I didn't have to cut the hood for the lightning stuff. But there is a slight clearance issue on the egr valve. That can be remedied by finessing the hood webbing. The hood insulation will need to...
  14. Replies
    16
    Views
    709

    https://www.ebay.com/itm/1986-Ford-Mustang-VJ1-Spe...

    https://www.ebay.com/itm/1986-Ford-Mustang-VJ1-Speed-Density-5-0L-Engine-Computer-ECM-ECU-PCM-Auto-v8-efi/192158792289?epid=1511162128&hash=item2cbd8e7a61:g:kwwAAOSw5ZBWHt9y
  15. Replies
    16
    Views
    709

    https://www.ebay.com/itm/ENGINE-COMPUTER-LINCOLN-M...

    https://www.ebay.com/itm/ENGINE-COMPUTER-LINCOLN-MARK-VII-1988-1989-1990-1991-1992-E9SF-12A650-SA-D9S-ECM/362900024574?hash=item547e86ecfe:g:20sAAOSw4pteNE-x
  16. Replies
    16
    Views
    709

    Don't waste your time with a manual computer...

    Don't waste your time with a manual computer unless you absolutely have to. The NDS wiring is different than the clutch switch wiring. It's 12 volts vs ground issue. So sending 12 volts to pin 30 of...
  17. If you're looking for a lower mileage 302 I got...

    If you're looking for a lower mileage 302 I got the one out of my coupe with 89K miles. Didn't burn oil, no knocks. Pulled it out to put 351w in.
  18. Replies
    16
    Views
    709

    You'll have better luck locating a D9S from a...

    You'll have better luck locating a D9S from a Mark VII. You're probably better off as it's a speed density ECU for basically a heavier mustang.
  19. If you do end up doing the intake gaskets, please...

    If you do end up doing the intake gaskets, please be aware that the corner bolts tend to corrode and will break off if you're not careful.
    Also while you got that out, you should replace the pcv...
  20. Thread: 351W Build

    by 86VickyLX
    Replies
    29
    Views
    1,678

    I have a 92 trans that does work. It could stand...

    I have a 92 trans that does work. It could stand to get serviced with some seals replaced and a valve body. A nice converter would probably help as well. It has park too! Just needs a broken bolt...
  21. Replies
    27
    Views
    1,050

    The ECM doesn't care what you're running past the...

    The ECM doesn't care what you're running past the O2 sensors.
  22. Replies
    11
    Views
    750

    The resistance value changes the opposite way and...

    The resistance value changes the opposite way and values are different.
  23. Replies
    11
    Views
    750

    They don't sell the efi sending units new. That...

    They don't sell the efi sending units new. That would be a junkyard or ebay NOS item. The stock pumps are controlled by a relay. Will need to get creative with the lines off the tank to go to the...
  24. Replies
    11
    Views
    750

    Your gas tank will not support a fuel pump. Your...

    Your gas tank will not support a fuel pump. Your gauge sending unit is also your feed and return line for your mechanical fuel pump. The intank pump is mounted on the trunk side of the tank. which...
  25. The LEDs I got were from amazon. They were from...

    The LEDs I got were from amazon. They were from the company NAO. never heard of them. but they were cheap enough. Just as an FYI, you will need to aim the headlights higher as the LEDs will project...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4
GMN Approved Links!


www.rockauto.com www.adtr.net