PotM GrandMarq.NET - Panther Headquarters Forum Index PotM
GMN Chat Room GMN's STORE!! GMN's Gallery Please!!

Search:

Type: Posts; User: 91waggin; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.01 seconds.

  1. Thread: Need help

    by 91waggin
    Replies
    34
    Views
    4,071

    In 89 they had both the red "Engine" and the...

    In 89 they had both the red "Engine" and the yellow "check engine." In 1990, when they changed the dash, they went to an actual temp gauge, an oil pressure warning light, and a yellow check engine.
  2. Replies
    15
    Views
    2,291

    At 190k I was in the same boat as gadget. Some...

    At 190k I was in the same boat as gadget. Some slop, but not scary. I only did it because I was resealing the cover and I was already in there.
  3. Replies
    17
    Views
    2,252

    My wagon has got a pretty loud fuel pump with the...

    My wagon has got a pretty loud fuel pump with the cargo area seats open too.
  4. Replies
    15
    Views
    3,238

    Don't mince words here...tell us how you really...

    Don't mince words here...tell us how you really feel!
  5. Replies
    21
    Views
    3,426

    Unhook the fuel line from the fuel filter and...

    Unhook the fuel line from the fuel filter and jumper the pump on at the self test connector. Have a big container ready to go that has high closed sides (fuel comes out of the hose at a pretty good...
  6. Replies
    30
    Views
    3,982

    It isn't that bad. 1 day project tops. The good...

    It isn't that bad. 1 day project tops. The good thing is that if you're oily all over the front of the motor you probably won't have much trouble getting the bolts out.
    Basically it's like doing a...
  7. Is the one carries alternator output electricity...

    Is the one carries alternator output electricity to the battery. If it's unhooked, alternator no chargee le batteree
  8. Sticky: That's easier.

    That's easier.
  9. Replies
    30
    Views
    3,982

    My first guess is that people putting oil in over...

    My first guess is that people putting oil in over the years didn't use funnel that often and spilled a lot. Then I'm going to guess timing cover gasket and P/S valve cover gasket.
  10. Replies
    16
    Views
    2,388

    Wait wait wait...the right turn signal on the...

    Wait wait wait...the right turn signal on the dash is on all the time?
    One of 3 things.
    --Bad bulb
    --Bad flasher
    --Bad turn signal switch

    Check in that order.
  11. I ended up running mine with the alternator...

    I ended up running mine with the alternator charge wire disconnected awhile ago (bad crimp on my part). I didn't know about it for awhile, but when the battery voltage finally started getting really...
  12. Sticky: Yellow wire senses battery voltage to properly...

    Yellow wire senses battery voltage to properly adjust alternator's output. Ford ran it to the solenoid so that it can sense actual battery voltage (since there's a pretty good voltage drop with the...
  13. Replies
    4
    Views
    1,004

    On my 91, you just unplug the 2 connectors,...

    On my 91, you just unplug the 2 connectors, unbolt 3 bolts, pull the wiper motor out a little bit and use a flathead screwdriver to disengage the little clip holding the motor to the wiper linkage.
  14. Basic standard Motorcraft copper plugs. Gap at...

    Basic standard Motorcraft copper plugs. Gap at .050. Should be less than $2.50 apiece. Don't put anything else in there. Don't let them upsell you to platinum iridium finewire kryptonite blah blah...
  15. Replies
    6
    Views
    1,078

    What year car is that? I'll see if I can pull the...

    What year car is that? I'll see if I can pull the wiring diagram. I can sure tell it isn't a 5.0 car.

    On many of these cars, the low fuel light is run by something called the Anti-Slosh module,...
  16. Replies
    30
    Views
    3,982

    IIRC, you put a wrench on the front bolt to get...

    IIRC, you put a wrench on the front bolt to get the tension, then you tighten the back one to hold it in place. Does that make sense?
  17. Replies
    15
    Views
    1,709

    Yup just did this. 1" socket. 6pt or 12pt,...

    Yup just did this. 1" socket. 6pt or 12pt, doesn't really matter since it's not in there that tight. But it does have to be a deep. Good luck finding a deepwell 1" socket in 3/8 drive; I don't think...
  18. Lopo knock probably isn't going to cause a...

    Lopo knock probably isn't going to cause a misfire like that. How old are ignition parts? Mine has leaky valve seals that fouls plugs relatively quickly (10,000 miles), and parts store plug wires...
  19. Replies
    36
    Views
    3,647

    :beer:

    :beer:
  20. Replies
    19
    Views
    2,643

    What ignition module do you has? Duraspark or...

    What ignition module do you has? Duraspark or TFI? Often ignition modules (GM's HEI does it too) will get hot and fail to provide (adequate, correctly timed) spark, but when they cool off they work...
  21. Been there done that a thousand times. I can...

    Been there done that a thousand times. I can never find the funnel when I need to, and I buy 5 quart jugs, so it gets messy sometimes.
  22. Here's my spiel on it. ...

    Here's my spiel on it.

    http://www.grandmarq.net/vb/showthread.php?50205-Turn-Key-Goes-Dead&p=717176&viewfull=1#post717176
  23. Replies
    15
    Views
    2,628

    Oh ok then, carry on. :) BTW when I did the...

    Oh ok then, carry on. :)

    BTW when I did the ACT and ECT sensors in my truck (93 302 F150) it helped a lot with high-revving on cold start as well as generally a lumpy shitty idle when cold.
  24. Replies
    99
    Views
    14,322

    Oh I'm all for a 2nd vehicle, hence Clifford (the...

    Oh I'm all for a 2nd vehicle, hence Clifford (the big red truck), my F-150. Buuuut I just hate rangers. That 4.0 v-6, whether OHV or SOHC, is just an evil motor.
  25. Replies
    7
    Views
    901

    Stupid things first-- Pull the lens off the...

    Stupid things first--

    Pull the lens off the dome light and tighten the screws under the bulb. One of them is a ground. It came loose on me one time.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4
GMN Approved Links!


www.rockauto.com www.adtr.net