PotM GrandMarq.NET - Panther Headquarters Forum Index PotM
GMN Chat Room GMN's STORE!! GMN's Gallery Please!!

Search:

Type: Posts; User: gadget73; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.26 seconds.

  1. Replies
    2
    Views
    74

    If yours has no antenna cable, it'll be plugged...

    If yours has no antenna cable, it'll be plugged into the stuff in the trunk. There should be a bypass harness that goes in the trunk to eliminate that, and you'll need an antenna extension cable to...
  2. No reason it can't work with the stock wiring. ...

    No reason it can't work with the stock wiring. The premium sound and electronic radios are the same, but one says Premium, the other says Electronic. Both will work with the amp in the trunk as...
  3. Replies
    175
    Views
    13,400

    trust me you aren't the only person that knew...

    trust me you aren't the only person that knew everything once upon a time. The older I get, the dumber I is.

    Sounds like that Sentra is a turd. Got a can of gasoline and a match? That'll fix...
  4. Replies
    231
    Views
    26,640

    i just use what the manual says to use. The...

    i just use what the manual says to use. The Ferds say F. I know the R&P in my Mark VII felt noticeably better with F vs Dex III. I doubt the steering box models care, though the Towncar was...
  5. Replies
    371
    Views
    29,144

    coolant in the oil? water fucks bearings fast and...

    coolant in the oil? water fucks bearings fast and hard. No lube either.
  6. Replies
    16
    Views
    273

    Some have a cooler between the EGR valve and the...

    Some have a cooler between the EGR valve and the intake. If you've got an oval thing with two coolant lines, thats the cooler. Sometimes that also gets packed up with carbon and causes trouble.
  7. Replies
    107
    Views
    6,773

    I've been pretty satisfied with my XE258 but my...

    I've been pretty satisfied with my XE258 but my heads are rather less than what you're going with.
  8. Most shops will just weld it up without the...

    Most shops will just weld it up without the flanges. Easier for them, sucks for you. For most people who just want the pipe to come out the back and don't care how it gets there, I suppose it just...
  9. Replies
    16
    Views
    273

    Replace the vacuum lines and the timing set. ...

    Replace the vacuum lines and the timing set. Timing on this is off a crank sensor, but the cam gear has plastic teeth and it doesn't hold up as well as the later steel ones. If it jumps the valves...
  10. Replies
    371
    Views
    29,144

    thinking head gasket? Running hot will thin the...

    thinking head gasket? Running hot will thin the oil out too much so that could be the real issue there.
  11. All of these will bleed down pressure after a...

    All of these will bleed down pressure after a while though. Even with everything new, 24 hours later its probably not holding any pressure in the line. I know mine never has. Doesn't stop it from...
  12. Replies
    38
    Views
    1,233

    usually losing 3+4 is direct clutch or direct...

    usually losing 3+4 is direct clutch or direct drum related. Thats the "other" typical fail method on the AOD if the OD band isn't the problem.
  13. Replies
    15
    Views
    275

    Whatever is on the shelf at most places is whats...

    Whatever is on the shelf at most places is whats in my car for the late model steering box swap. Been there for years, still fine. The holes weren't perfectly aligned on that either but it goes...
  14. Replies
    4
    Views
    158

    ah, I was thinking the ones on the cross-pin. I...

    ah, I was thinking the ones on the cross-pin. I know the ones on the axle side are different for the clutches.
  15. The pump prime cycle is purely time-based. It...

    The pump prime cycle is purely time-based. It has nothing to do with how fast it ramps up pressure. The ECM has no way of knowing that anyway. It turns on for however many seconds the ECM commands...
  16. Replies
    4
    Views
    158

    are the spiders on the open carriers the same? ...

    are the spiders on the open carriers the same? Not sure axle spline count has anything to do with it, unless you mean the side gears where the axle actually comes into the carrier.
  17. Replies
    15
    Views
    275

    the rags usually fail from oil exposure, and the...

    the rags usually fail from oil exposure, and the only thing that should make a huge mess right in that area is something in the power steering system leaking.
  18. If you have right angle retaining ring pliers,...

    If you have right angle retaining ring pliers, those will often stand in for one.
  19. Replies
    15
    Views
    275

    Its two piece but there isn't much need to take...

    Its two piece but there isn't much need to take it apart if it will actually slide. Mine was rusted fast and had to be heated considerably to move in order to get the box out and back in. Shoot some...
  20. Replies
    12
    Views
    393

    Everyone is entitled to their incorrect opinions....

    Everyone is entitled to their incorrect opinions.

    dunno, I just have never been a fan of most cars from about 1972 onward. Once they got those big idiotic bumpers and then re-designed the cars to...
  21. Replies
    38
    Views
    1,233

    Nice AC compressor bracket :) Sounds good. ...

    Nice AC compressor bracket :)

    Sounds good. Shame the trans went TU that quick. What cam is in there? Not nearly as lumpy as the one on my Towncar. I like it.
  22. sure its not just the pump relay itself sticking?...

    sure its not just the pump relay itself sticking? I've had relays die by staying on before, though that shouldn't affect it being able to start.
  23. Replies
    33
    Views
    4,560

    long offset box wrench seems to work well,...

    long offset box wrench seems to work well, ideally a 6 point one so it won't round off the bleeder.
  24. Awesome, love an easy fix.

    Awesome, love an easy fix.
  25. Replies
    12
    Views
    393

    never cared for the IV all that much. The lines...

    never cared for the IV all that much. The lines are too soft and proportionally it just looks wrong to me. Cars got horrible in the 70s, it was all too big and bloated. They lost the clean lines...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4
GMN Approved Links!


www.rockauto.com www.adtr.net