PotM GrandMarq.NET - Panther Headquarters Forum Index PotM
GMN Chat Room GMN's STORE!! GMN's Gallery Please!!

Search:

Type: Posts; User: gadget73; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.28 seconds.

  1. Replies
    12
    Views
    249

    might also want to take note of what timing cover...

    might also want to take note of what timing cover is on that thing. There is a reverse flow pump one that doesn't work with the pump you need for stock belt setups.
    ...
  2. Replies
    16
    Views
    295

    can you see down into the valley under the...

    can you see down into the valley under the intake? There is a hose in there that can go and you won't see it until it fills the valley up with coolant and dumps out the back. Not familiar with the...
  3. Replies
    3
    Views
    144

    I use a plastic pry bar trim removal thing I got...

    I use a plastic pry bar trim removal thing I got from Harbor Freight, but I did still manage to slightly bend the trim on the Continental. Agree on it seeming a bit brutal to remove, but I guess...
  4. Replies
    12
    Views
    249

    Alt and PS bracket is the same, its the AC...

    Alt and PS bracket is the same, its the AC bracket that is specific for the 351. I think only one bolt gets used vs 2 though. Use the proper water pump for the engine, it all just fits together...
  5. Replies
    4
    Views
    117

    May as well. make sure you don't over-torque...

    May as well.

    make sure you don't over-torque the filter. I had problems with OD engagement on something and later info makes me think it was the filter bolt being too tight and causing the...
  6. Replies
    21
    Views
    1,175

    Wonder if vintage fuel has any value. Sell it to...

    Wonder if vintage fuel has any value. Sell it to the "retro everything" crowd. Genuine pre-COVID gasoline, low miles, second owner. No lowballers, I know what I have.
  7. Replies
    82
    Views
    6,269

    always thought those prancing moose emblems were...

    always thought those prancing moose emblems were funny but its even more appropriate on a red brick. The Saab troll stickers are also funny.
  8. Replies
    20
    Views
    1,349

    I'd honestly check the ground in the trunk first,...

    I'd honestly check the ground in the trunk first, probably the more accessible item. Also more likely to be at fault if the resistance directly at the sender reads normally.

    Might also have to...
  9. Replies
    3
    Views
    144

    there is a nut at the rear edge of the door, make...

    there is a nut at the rear edge of the door, make sure that is off. I think there is a screw up front too but its been a while since I had mine off. The keypad wire does need some slack in it, not...
  10. Replies
    4
    Views
    228

    I've never seen service docs for any of this...

    I've never seen service docs for any of this stuff. I guess that was all held secret. Radio service manuals exist so I'm assuming info for the other stuff existed somewhere but no idea where.

    ...
  11. Replies
    182
    Views
    47,782

    Sticky: The H pipe actually flows better than straight...

    The H pipe actually flows better than straight duals, makes more torque. personally I think it sounds better but thats entirely subjective.
  12. Replies
    182
    Views
    47,782

    Sticky: honestly there isn't much advantage to a better...

    honestly there isn't much advantage to a better intake on an otherwise stock motor. People have put Explorer intakes on and it lost low end torque without gaining much on the top end. The HO upper...
  13. Replies
    2
    Views
    129

    The buzzing noise? Thats the air suspension...

    The buzzing noise? Thats the air suspension compressor. The rubber mounts are probably bad, it should not be that loud.

    If you mean the "ting" noise when you let off the starter, that might just...
  14. Replies
    4,903
    Views
    679,919

    I'm kind of wheeling back towards stock or at...

    I'm kind of wheeling back towards stock or at least period-correct appearance myself. Anachronistic things look out of place.
  15. Replies
    11
    Views
    360

    The 100 amp is externally regulated and a larger...

    The 100 amp is externally regulated and a larger case, so it requires a lot of re-wiring and a different bracket to install one. Going the other way requires at least wire mods, there is a large...
  16. Replies
    707
    Views
    63,640

    closeness to the edge was my concern with the...

    closeness to the edge was my concern with the rivnuts. Don't want to drill through and find there isn't enough material for it to actually work. I have a slightly better tool to install them, but...
  17. Replies
    4
    Views
    228

    I'd wager on internal power supply issues. ...

    I'd wager on internal power supply issues. Probably the standard bad capacitors answer.
  18. Replies
    20
    Views
    1,349

    I put one of the trunk closers in my base model...

    I put one of the trunk closers in my base model that didn't come with it. Its entirely a "oooh, lookie at the fancy car" thing. Functionally the latch I removed is probably a better idea.

    make...
  19. Replies
    707
    Views
    63,640

    those lower shock mounts are not very good. Mine...

    those lower shock mounts are not very good. Mine stripped out a long time ago. I have some crappy speed nuts in there holding it together but at some point in the future I really should come up with...
  20. Replies
    8
    Views
    264

    ever checked the fuel filter? Might have sucked...

    ever checked the fuel filter? Might have sucked up some trash and plugged the filter.
  21. Replies
    59
    Views
    4,428

    I used a 1/4" jack because its what I had laying...

    I used a 1/4" jack because its what I had laying around at the time. The current install uses a 3.5mm that is in the panel directly below the radio. The dash trim on the Conti is such that there is...
  22. Replies
    11
    Views
    360

    I changed one with my useful hand in a cast once...

    I changed one with my useful hand in a cast once with basically the same procedure. I had a thumb and a finger that was usable on my right hand, so I had the pry bar hooked in my elbow and the box...
  23. Replies
    59
    Views
    4,428

    yeah the belts stretch. You're lucky it was just...

    yeah the belts stretch. You're lucky it was just loose, sometimes they turn into black sticky goo that is a huge pain in the ass to clean up.


    Stick a pair of spoons under the stuck knob and...
  24. 95-97 I think had electric and clutch. The...

    95-97 I think had electric and clutch. The clutch fan was the primary cooling, electric was for AC and I think it would engage if the engine got too hot. For a bit people thought the cool free...
  25. Thread: To much fuel

    by gadget73
    Replies
    51
    Views
    3,646

    might want to start a separate thread for that,...

    might want to start a separate thread for that, easier to keep track of. I believe the check valve is built into the pump though.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4
GMN Approved Links!


www.rockauto.com www.adtr.net