PotM GrandMarq.NET - Panther Headquarters Forum Index PotM
GMN Chat Room GMN's STORE!! GMN's Gallery Please!!

Search:

Type: Posts; User: sly; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.16 seconds.

  1. Replies
    5
    Views
    107

    Avoid 03/04 cars with less than 130K miles on...

    Avoid 03/04 cars with less than 130K miles on them. The rear axles usually fail within that amount of mileage. Replacements typically last longer. 05 had some weird one-year stuff to it along with...
  2. If the valve is leaking THROUGH and not just...

    If the valve is leaking THROUGH and not just down... it could cause a problem. I'm not totally sure on how they are made so I can't say whether that's possible or not, but yeah, if the valve is...
  3. That manual control would cost about as much as...

    That manual control would cost about as much as harvesting ALL the needed stuff from a salvage yard and buying new air springs or shocks depending on the setup. And I think the point of it all is to...
  4. Thread: Help

    by sly
    Replies
    5
    Views
    174

    no prob. It is under the hood. Look on the...

    no prob. It is under the hood. Look on the passenger side of the car and you'll find the black plastic housing of the HVAC plenum that the blower is mounted on. Look through the screen on top of the...
  5. If the relay clicks, the ECM is switching the AC...

    If the relay clicks, the ECM is switching the AC off because it thinks the throttle is wide open. Check the TPS sensor. The relay should not click when installed unless the key is on and engine is...
  6. Looks like you may need to clean out said EGR...

    Looks like you may need to clean out said EGR valve. That's a a lot of carbon build up on those ports. If the vacuum lines are cracky or really soft and squishy, then replace them. If they are firm...
  7. Replies
    423
    Views
    24,996

    I'd just overlap by about a quarter inch and go...

    I'd just overlap by about a quarter inch and go to town, but then I have no illusions of doing any proper welding. I'd just make it stay put and seam seal the crap out of it after grinding all my...
  8. Thread: Help

    by sly
    Replies
    5
    Views
    174

    check the HVAC vent drain hole. If it gets...

    check the HVAC vent drain hole. If it gets clogged, it tends to flood the car. That's actually the usual suspect for that. Also check the gasket under the vent screen. It can be replaced with any...
  9. Replies
    16
    Views
    325

    Worth it. Also... your car... too low is when you...

    Worth it. Also... your car... too low is when you don't like it. My actual opinion is that too low is when speed bumps scrape the bottom.
  10. Replies
    16
    Views
    325

    Anything below stock CVPI height is too low for...

    Anything below stock CVPI height is too low for me. Yeah... my LX is raised an inch or so.
  11. Replies
    4,679
    Views
    522,370

    This. The SRT8 Super Bee is quite a beast.

    This. The SRT8 Super Bee is quite a beast.
  12. Thread: Scottfest 2019

    by sly
    Replies
    5
    Views
    235

    You'd think that... but considering most of the...

    You'd think that... but considering most of the places I want to go don't have campgrounds when not in a national park, having a nice place to take a piss at 4am when Nature is being a pisser without...
  13. Thread: Scottfest 2019

    by sly
    Replies
    5
    Views
    235

    Not this year. Next year more than likely...

    Not this year. Next year more than likely though... maybe even with a camper trailer. Been on the hunt. Either find a little too much rot or just missing the bits I want (shower/shitter) for family...
  14. Replies
    926
    Views
    100,787

    Dang dude. That's actually really nice.

    Dang dude. That's actually really nice.
  15. Replies
    4
    Views
    160

    52253

    52253
  16. Replies
    423
    Views
    24,996

    Pretty much this. It either grenades or won't...

    Pretty much this. It either grenades or won't shift out of first.
  17. Nice.

    Nice.
  18. Thread: Third Brake Light

    by sly
    Replies
    2
    Views
    153

    IIRC, those are pan head Phillips panel screws....

    IIRC, those are pan head Phillips panel screws. Like the ones holding the dash pad down, but without the extended flat area, and a little shorter.
  19. Replies
    423
    Views
    24,996

    From what I remember about posts here and there...

    From what I remember about posts here and there for CFI cars, TV rod transmission up to like 84 I think fail to high pressure. After that it changed to failure of destruction.
  20. I'm still not seeing anything. Weird.

    I'm still not seeing anything. Weird.
  21. Replies
    4
    Views
    179

    I haven't seen those on many panels. The Phillips...

    I haven't seen those on many panels. The Phillips screw head type I see a LOT more often.
  22. Replies
    21
    Views
    589

    Can verify the early aero part. My 93 has the...

    Can verify the early aero part. My 93 has the round key for the trunk.
  23. Replies
    4
    Views
    179

    Panel clips. Just a screw type or push pin type...

    Panel clips. Just a screw type or push pin type unlike the older finned (christmas tree) type like on my 93 (which needs new ones bad).

    Here's an Amazon link:...
  24. Replies
    4
    Views
    192

    Glad you got it sorted.

    Glad you got it sorted.
  25. Replies
    4
    Views
    168

    Grab the wire from the O2 sensor. Follow it back...

    Grab the wire from the O2 sensor. Follow it back to its harness. Follow that harness back to the next harness. There should only be two in line from the O2 sensor to the PCM IIRC.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4
GMN Approved Links!


www.rockauto.com www.adtr.net