PotM GrandMarq.NET - Panther Headquarters Forum Index PotM
GMN Chat Room GMN's STORE!! GMN's Gallery Please!!

Search:

Type: Posts; User: 86VickyLX; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.10 seconds; generated 23 minute(s) ago.

  1. Replies
    14
    Views
    388

    Maybe we can work something out?

    Maybe we can work something out?
  2. Replies
    14
    Views
    388

    Yes, it's been done. I have information that may...

    Yes, it's been done. I have information that may allow the Mustang ECU control cruise control. The hardware is there. It's basically a 90/91 California Mass air car. All you need to do is move the...
  3. Replies
    12
    Views
    505

    Odd because I had to clearance the covers and the...

    Odd because I had to clearance the covers and the end rockers so they didn't hit. Maybe the edelbrock heads are different. I know the crane rockers will clear no problem.
  4. Replies
    19
    Views
    462

    2 grounds actually. Ground is accomplished...

    2 grounds actually. Ground is accomplished through the brake lamps and vss-. 87+ is the 3rd brake light specifically, which is why cruise disengages on 86 and down when the hazards are on. and...
  5. Replies
    12
    Views
    413

    I am guilty of this many times.

    I am guilty of this many times.
  6. Replies
    12
    Views
    505

    There was 1 lopo that I know of that had 1.7...

    There was 1 lopo that I know of that had 1.7 rockers. That was the boulevard cruiser (89 colony park). It ran great. Also had HO intake, and stock mustang shorty headers and an exhaust. If you change...
  7. Hey dude. Long time no see. Looks like a good one...

    Hey dude. Long time no see. Looks like a good one to start with!
  8. Replies
    8
    Views
    378

    If the solenoid failed in the closed position,...

    If the solenoid failed in the closed position, then it could be the cause of your issue. You can check by applying power and ground to the solenoid and see if it clicks. You can also see if the...
  9. Replies
    8
    Views
    378

    Check the steering shafts. My 98's intermediate...

    Check the steering shafts. My 98's intermediate shaft (goes between lower and column) u joint was completely rusted solid and did not move. I replaced that and the lower shaft with new Ford parts...
  10. 21 not plugged in or not warmed up. the coolant...

    21 not plugged in or not warmed up. the coolant temp sensor is on passenger side of engine in the pipe. The one on the drivers side is sender for light.
    24 not plugged in or bad sensor. Check wiring...
  11. Thread: Gph / rpm

    by 86VickyLX
    Replies
    7
    Views
    311

    It's a generalization. It won't give you exact as...

    It's a generalization. It won't give you exact as the display on the tool doesn't match the car as far as fuel economy, if anything it's a little more towards the efficient side vs what the on board...
  12. Replies
    4
    Views
    254

    Is there a female pin on the other half?

    Is there a female pin on the other half?
  13. Replies
    411
    Views
    38,388

    Maybe the PCM driven EDIS is able to operate both...

    Maybe the PCM driven EDIS is able to operate both coils? I honestly couldn't tell you why it didn't work.
  14. Replies
    411
    Views
    38,388

    I hope you're swapping the computer as well....

    I hope you're swapping the computer as well. Because you can't wire up the COP coils like a waste spark. They just don't work for some reason. Thain went through all that crap with Jason's 93 when we...
  15. Replies
    11
    Views
    486

    However, I think you can enable PATS with a...

    However, I think you can enable PATS with a tuner. You can disable it on other ecms if I'm not mistaken.
  16. Replies
    11
    Views
    486

    No. The ecm will not work. The way the fuel pump...

    No. The ecm will not work. The way the fuel pump is controlled is completely different. 03 introduced the fuel pump driver module. 99 still used a fuel pump relay. There are differences in how the...
  17. Replies
    6
    Views
    392

    Convert it. easy peasy

    Convert it. easy peasy
  18. Replies
    3
    Views
    248

    Basically, just go by whatever Ford used on the...

    Basically, just go by whatever Ford used on the later vehicles. The fuel pump power wire gets a 20 amp fuse. The EEC power relay gets 30 amps. The rear defroster grid gets a 40 amp fuse. Ideally if...
  19. Replies
    65
    Views
    4,443

    That was one other thing I was concerned about....

    That was one other thing I was concerned about. It was a tight fit as it was.
  20. Replies
    65
    Views
    4,443

    Simple. Tall valve covers don't allow upper...

    Simple. Tall valve covers don't allow upper intake to clear without a spacer. Any more height and I was definitely running into issues. The Lightning/tubular upper is the lowest profile and the...
  21. Replies
    65
    Views
    4,443

    Picture Dump

    Engine in. Then a shot of the tailpipes. Police rear sway bar installed. And a shot of the tripminder going on a trip to the Pumpkin Run back in November.
  22. Replies
    65
    Views
    4,443

    Picture Dump

    Engine out. Engine in, radiator installed.
  23. Replies
    65
    Views
    4,443

    Picture Dump

    In this collection. You'll see the rear from Blue, derusted and painted. Also the big brake swap pieces from Blue also derusted and painted. Or at least one side. This happened over a few days of...
  24. Replies
    65
    Views
    4,443

    Picture Dump

    You can see I finally got my head out of my ass and installed the Powered By Ford valve covers, and swapped over to the 39lb fuel injectors. At this point the engine is ready for install. Also...
  25. Replies
    65
    Views
    4,443

    Picture Dump

    More photos. I was playing around with other valve covers which proved to be too stupidly tall to be used in order for my hood to clear. You can also see mock up of 3g alternator case, and the...
Results 1 to 25 of 492
Page 1 of 20 1 2 3 4
GMN Approved Links!


www.rockauto.com www.adtr.net