PotM GrandMarq.NET - Panther Headquarters Forum Index PotM
GMN Chat Room GMN's STORE!! GMN's Gallery Please!!

Search:

Type: Posts; User: BoulevardRide; Keyword(s):

Page 1 of 7 1 2 3 4

Search: Search took 0.00 seconds.

  1. Replies
    24
    Views
    609

    I never had any luck counting flashes myself. ...

    I never had any luck counting flashes myself. Tho lots of guys here seem to be good at it.
    If you can afford the 50 bucks this code reader worked well for me...
  2. Replies
    13
    Views
    302

    Cool lookin car. Hope it works out for you. ...

    Cool lookin car. Hope it works out for you. I've owned cars from the big 3 from the 60s-90s and have found Ford products to be better built overall. Once you correct the fatal flaws.

    In...
  3. I had 2 of those rims that look like the ones the...

    I had 2 of those rims that look like the ones the OP pictured above, kind of hard to tell, they were marked 97 and came off a 97TC, ran them on the front of my 88 no problem
    53755

    Also ran a full...
  4. Replies
    19
    Views
    462

    Yeah it's amazing there are still some 70s cars...

    Yeah it's amazing there are still some 70s cars for sale running, back then 100,000 miles was pretty much the death knell. Just last year prices on 70s cars were still pretty cheap but they seem to...
  5. Replies
    411
    Views
    38,388

    When i worked at a bike shop we'd put grease on...

    When i worked at a bike shop we'd put grease on the tap to keep shreds out of the engine.
    Never heard of an aluminum magnet, will have to look that up. always learning something here
  6. Replies
    19
    Views
    462

    Thanks Wolf. At this point I'd only buy a car...

    Thanks Wolf. At this point I'd only buy a car with cruise installed, I'm past the point of grafting a complete junkyard 90s truck system into a 70s sedan, and so forth. with help here i feel i can...
  7. Replies
    19
    Views
    462

    Thanks for the responses. A standalone speed...

    Thanks for the responses. A standalone speed control system sounds like the way to go for someone with limited diagnostics.

    Are the necessary parts still available going back to the 70s/early...
  8. Replies
    19
    Views
    462

    Thanks for the explanation. I understand the...

    Thanks for the explanation. I understand the basics but the finer points still elude me. Is the servo where the vacuum lines go?

    And how much vacuum does it take to lug a 5,000lb tank uphill...
  9. Replies
    19
    Views
    462

    Cruise control w/carb?

    On the early models with carburetor... how complex is the cruise control system? Is there a computer module, or is it just vacuum lines and switches? Is it basically the same as the cc in the 1970s...
  10. Ad says it sat for 25 years. How do the seals...

    Ad says it sat for 25 years. How do the seals hold up on these older ones, is it going to start puking fluids on the first road trip?
  11. Cool old Merc, can't beat a 70s big block for...

    Cool old Merc, can't beat a 70s big block for luxury cruising. I would like one too someday.
  12. Replies
    15
    Views
    622

    Cool lookin car. armrest doesn't look bad and...

    Cool lookin car. armrest doesn't look bad and red duct tape is fun. will be on the lookout for a set of those geometric wheels.
  13. Nice looking ride, that 2-tone blue you are doing...

    Nice looking ride, that 2-tone blue you are doing looks real good. Looks pretty clean underneath too.
    You guys amaze me with the knowledge and just diving into stuff I will never understand. ...
  14. Replies
    15
    Views
    775

    Well I got a decent deal on the ebay radio and it...

    Well I got a decent deal on the ebay radio and it works great. Nice to have tunes again. I ran out of low offers so the mrs. had to make 2 more before it got accepted. got it for about the same...
  15. Replies
    15
    Views
    775

    Well my highly qualified mechanic (me) performed...

    Well my highly qualified mechanic (me) performed the sophisticated electronics diagnosis procedure (wiggling the harness) with no new life seen in the radio. So i ordered up a new used one, will see...
  16. Replies
    15
    Views
    775

    I bought a nice set of tools and the radio came...

    I bought a nice set of tools and the radio came right out. There is what looks like a ground tab on the back of the case with no ground wire visible in the dash.

    If you look at the pic above from...
  17. Replies
    23
    Views
    879

    Well don't feel bad, my pump puked out the seal...

    Well don't feel bad, my pump puked out the seal last year, was gushing so bad i had a shop haul it off on a flatbed. Triple-A covered the tow but $350 later i had a new pump in there. All for a...
  18. Replies
    21
    Views
    830

    Nice car and pickup. Looks like a pretty big cam...

    Nice car and pickup. Looks like a pretty big cam and pretty short skirts on those pistons.
    There's a 69 convertible for sale for a while near me, guy leaves it out year-round on Rt1 heading...
  19. Replies
    15
    Views
    775

    Ok thanks. time to get a set of those pin...

    Ok thanks. time to get a set of those pin removal tools and take a look at the connections...
  20. Replies
    15
    Views
    775

    Thanks Mr Bean. I would prefer a straight swap,...

    Thanks Mr Bean. I would prefer a straight swap, no adapters or cutting wires.

    The ads i have seen say my radio is 95/96/97, are these the only years that will plug right in then? does it have...
  21. Replies
    15
    Views
    775

    radio compatibility?

    what year factory radio/cassette will work in my 96 mgm? i.e. will a 2000 explorer unit work, they are easier to find... and cheaper. mine looks like this...
  22. Replies
    28
    Views
    1,430

    Hi Tom, for brake lines I let them put on...

    Hi Tom, for brake lines I let them put on whatever they recommend. The guy who did the rear crossover last week, told me last year when he did my Lincoln that they use copper or nickel or something,...
  23. Replies
    1
    Views
    513

    Shocks have been sold, to a member here. thank...

    Shocks have been sold, to a member here. thank you
  24. Replies
    28
    Views
    1,430

    This frame is good, body is good, there is a fair...

    This frame is good, body is good, there is a fair amount of rust on some underneath incidentals, mostly threads and fasteners, will have it undercoated in a couple weeks once i'm done getting it...
  25. I'm pretty sure 88 was the year they went to the...

    I'm pretty sure 88 was the year they went to the steel cam gear, before that it was plastic teeth. Plastic gets brittle with age as well as mileage/heat cycles, so you may want to verify that gear...
Results 1 to 25 of 159
Page 1 of 7 1 2 3 4
GMN Approved Links!


www.rockauto.com www.adtr.net