PotM GrandMarq.NET - Panther Headquarters Forum Index PotM
GMN Chat Room GMN's STORE!! GMN's Gallery Please!!

Search:

Type: Posts; User: Arquemann; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    7
    Views
    89

    If the pistons don't move freely, rebuild or...

    If the pistons don't move freely, rebuild or replace the calipers. If you manage to unseize the piston, make damn sure it keeps moving freely and evenly, they will easily stick again.
    Box calipers...
  2. Replies
    13
    Views
    310

    Thank you very much for those, I do remember...

    Thank you very much for those, I do remember seeing atleast 2 of those pages before, but I couldn't find them. I'll be sure to save these ones.

    I can see exactly what I found out with the fuel and...
  3. Replies
    13
    Views
    310

    Apparently the fuel pump relay has TWO power...

    Apparently the fuel pump relay has TWO power sources, one that's hot at all times and for some reason there's another one that's only hot when cranking??
    Caused me some headache to figure out why...
  4. Replies
    451
    Views
    45,888

    I got a chance to drive a stock '84 Crown Vic...

    I got a chance to drive a stock '84 Crown Vic wagon on Friday... Ended up parking it on a curb and crawling underneath it.
    The thing felt FAST compared to my sedan!

    Factory CFI 302, nothing...
  5. Replies
    13
    Views
    310

    Today I did a little digging into the driver rear...

    Today I did a little digging into the driver rear corner of the engine bay. Basically just verified that the EEC power relay gets a key-on signal even with the ECM disconnected. And that the fuel...
  6. Replies
    13
    Views
    310

    I'm guessing the EEC power relay gets key-on...

    I'm guessing the EEC power relay gets key-on power straight from the ign switch? Could it be a good place to get key-on power for the fuel pump (I'll keep the factory relay) and for ignition coil? Is...
  7. Replies
    13
    Views
    310

    Wiring diagrams for '85 MGM

    Mainly looking for how the engine harness is tied to other wiring in the car.
    I'm going carb on my car so I have stuff to figure out.

    Mostly if the AC/heat and cruise control is tied to the...
  8. Thread: Build theme

    by Arquemann
    Replies
    23
    Views
    406

    Uhh... Lincoln Continental Mark 7 & 8? Especially...

    Uhh... Lincoln Continental Mark 7 & 8? Especially the Mark 8 with the 4V modular.



    Focus CC with ST engine maybe? There's also those Jackson Racing superchargers for the SVT models. If you're...
  9. Thread: Build theme

    by Arquemann
    Replies
    23
    Views
    406

    LTC Jack Nicklaus Special Edition. Fucking...

    LTC Jack Nicklaus Special Edition.

    Fucking GREEN carpet with white interior... The outside is green and white aswell.

    I'd really like a shoebox Ford or Mercury with the Lincoln flatty V12. Call...
  10. Replies
    11
    Views
    349

    MGM LS models got "18 ounce cut-pile carpeting"...

    MGM LS models got "18 ounce cut-pile carpeting" as standard, but it was an option on GS and other lower trims I think. 16 ounce for those.
    I'd guess Ford models got the 16 ounce aswell or something...
  11. Now that this issue seems to have been solved, is...

    Now that this issue seems to have been solved, is your ride starting to be somewhat sorted out?
    On mine the troubleshooting has lasted 2 years... and is going to end in removing the thing that...
  12. I think you mentioned the curb idle quite a while...

    I think you mentioned the curb idle quite a while back. Did you pull too many hairs before realising this?
    The correct curb idle is kinda on the high side, so you might've not realised that you idle...
  13. Replies
    451
    Views
    45,888

    I've been thinking through the upcoming carb...

    I've been thinking through the upcoming carb swap, and while the basics are pretty clear to me, I've been pondering on the two dozen little things; mostly electrical.
    So I've got a few questions...
  14. Replies
    145
    Views
    16,906

    Here's what I had in mine, original '85 MGM ECM...

    Here's what I had in mine, original '85 MGM ECM non-california, I don't think the other side had any print.
    57022

    I wouldn't expect the Mustang CFI ECMs to be so different from panther ECMs that...
  15. Replies
    145
    Views
    16,906

    Oh I would too, but I'm broke asf so I'm going...

    Oh I would too, but I'm broke asf so I'm going carb. Swapping to a Holley Sniper is a lot more work than a carb swap aswell, but probably well worth it. If I had money laying around, I'd probably go...
  16. Replies
    145
    Views
    16,906

    Until now, a built motor (or even slightly...

    Until now, a built motor (or even slightly modified) and CFI hasn't really been spoken in the same sentence, as so many have screamed that you can't do shit with CFI. @sluggish91 has pioneered CFI...
  17. Replies
    145
    Views
    16,906

    I find the experimentation interesting, but as is...

    I find the experimentation interesting, but as is evident, a wasted effort in a sense. Everything can work, but is it worth it? No.
    CFI/TBI is just the next step from electronically controlled...
  18. Replies
    145
    Views
    16,906

    Oh hell yes! I found this a while back,...

    Oh hell yes!

    I found this a while back, someone has gone mad aswell. But in a similarly good way:
    https://www.msextra.com/forums/viewtopic.php?f=101&t=70311
  19. Replies
    20
    Views
    552

    I personally wouldn't use time and effort to try...

    I personally wouldn't use time and effort to try and make a box lighter, but I am still quite interested in making a box handle better. Nothing too crazy, but I want to be able enjoy twisty roads...
  20. Replies
    11
    Views
    357

    Your rear axle.

    Your rear axle.
  21. Replies
    407
    Views
    71,690

    OEM stuff is expensive as shit when it comes to...

    OEM stuff is expensive as shit when it comes to german cars. Probably comes as no surprise but especially german cars really should be fixed with quality parts. But not going to the stealership...
  22. Replies
    20
    Views
    552

    Along what you mentioned, maybe the spare tire &...

    Along what you mentioned, maybe the spare tire & holder, bumper jack. Unless you want to bastardize the interior comfort, you can't do much inside, maybe convert to manual windows and mirrors? :D...
  23. Replies
    407
    Views
    71,690

    And this gen is probably one of most common to...

    And this gen is probably one of most common to see in Finland. The next gen and it's facelift models aren't as common somehow.
    Folks are still importing W211s from Germany and Sweden. No def shit...
  24. Replies
    2,089
    Views
    247,318

    Are you sure about that? :lol3:...

    Are you sure about that? :lol3: https://autot.tori.fi/vaihtoautot/opel/rekord/70272023 (it's for a whole car, not parts)

    I don't know why, but to me that color and those wheels just scream box...
  25. Replies
    451
    Views
    45,888

    Google doesn't find anything with that PN. I...

    Google doesn't find anything with that PN. I don't know if its the same on all boxes but the clips I had were like button heads that slid sideways on to the nubs on the car.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4
GMN Approved Links!


www.rockauto.com www.adtr.net