PotM GrandMarq.NET - Panther Headquarters Forum Index PotM
GMN Chat Room GMN's STORE!! GMN's Gallery Please!!

Search:

Type: Posts; User: 86VickyLX; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.09 seconds.

  1. I want to see if your car will still have cruise...

    I want to see if your car will still have cruise control after you do the mass air swap. I have reason to believe the mustang ECU has the capability of running cruise control. Based on the...
  2. I suggest hitting up a demo derby group to find...

    I suggest hitting up a demo derby group to find the a/c bracketry.
  3. Replies
    18
    Views
    653

    That sounds oddly familiar.

    That sounds oddly familiar.
  4. You will use your oilpan. You will need an oil...

    You will use your oilpan. You will need an oil pickup tube for a panther/mustang. Ideally the explorer injectors are better but the mark vii pcm is expecting the old style 19lb injectors so fueling...
  5. My hazard flasher stopped flashing after...

    My hazard flasher stopped flashing after converting to LEDs so I had to replace both.
  6. Replies
    8
    Views
    357

    03 may be a tune. Unless you have a vss with a...

    03 may be a tune. Unless you have a vss with a gear on the extension housing on the drivers side.
  7. It's really bad in the coupe. I'm seriously...

    It's really bad in the coupe. I'm seriously debating having quieter mufflers put on.
  8. It's not too bad if you can tune it out with the...

    It's not too bad if you can tune it out with the radio. The stock sound system is inadequate for that.
  9. Replies
    18
    Views
    653

    Transmission cooler is in the a/c condenser in...

    Transmission cooler is in the a/c condenser in 06+ crown vics.
  10. Replies
    17
    Views
    662

    Try to get a sound clip of it. I'm curious if...

    Try to get a sound clip of it. I'm curious if it's the timing chain tensioners/guide being the problem.
  11. The listings are messed up. And to be honest with...

    The listings are messed up. And to be honest with you I don't know which would be the correct window motor. The door lock actuators themselves are the same. The rod may be different however. The rod...
  12. The tailgate won't go down until the window goes...

    The tailgate won't go down until the window goes down.
    The window won't go down if the latch isn't engaged fully. There's a switch on one of the latches that completes the circuit for the window...
  13. Inspect your intake and see if it still has the...

    Inspect your intake and see if it still has the plastic coolant crossover in the front. If it does plan on finding a PI manifold for an 03. Don't get the dorman! If it already has a dorman on it....
  14. It'll be loud and droney! Ask me how I know hehe.

    It'll be loud and droney! Ask me how I know hehe.
  15. I'm doing that now 350hp (supposedly, with...

    I'm doing that now 350hp (supposedly, with calculations based on airflow and whatnot at the crank) and 400 ftlbs of torque. It's a little slower because of the AOD and 3.27s. Still need to finish...
  16. Replies
    5
    Views
    255

    If you can remove them you can probably unstick...

    If you can remove them you can probably unstick them. You can also see if it's the seatbelt mechanism itself that's binding up and not allowing the plunger to come back out.
  17. Replies
    8
    Views
    369

    Let me check though I think I just threw all that...

    Let me check though I think I just threw all that crap out.

    *Edit* Nope it's gone. This normally happens when I throw stuff out "No one will ever need this." :/
  18. Replies
    44
    Views
    2,945

    Fun fact! You don't need an intake spacer to run...

    Fun fact! You don't need an intake spacer to run those on an EFI 351w. If you're using lightning upper intake, the bracket that holds cruise/throttle/tv cable fits right between the fins. JUST BARELY...
  19. Replies
    5
    Views
    255

    The plungers are pushed in? The plungers twist 90...

    The plungers are pushed in? The plungers twist 90 degrees and pull out. Then there's a cable that is attached to the plunger to the release mechanism. If you can get new plungers and cables, please...
  20. Replies
    1
    Views
    154

    You need the 92 parking brake cables. for the...

    You need the 92 parking brake cables. for the rear. I think you won't even need to modify anything to make it work as the 90-91 has the same parking brake pedal assembly. The passenger rear goes...
  21. The explorer upper hits the hood drastically...

    The explorer upper hits the hood drastically more.You will have to cut out a considerable amount of webbing from the inside of the hood to make it clear.
  22. I have a GT40 351w lower intake if you're...

    I have a GT40 351w lower intake if you're interested. It's powdercoated black. It's the marine intake so it's made out of cast iron instead of aluminum. I've done the 351w in a coupe thing. My 86 Two...
  23. Replies
    91
    Views
    3,431

    The tank doesn't suck when the nuts come separate...

    The tank doesn't suck when the nuts come separate from the studs. Took me 10 minutes to do the tank in the coupe because the nuts actually came off the studs.
  24. The CD changer is mounted on the drivers side of...

    The CD changer is mounted on the drivers side of the trunk. If you don't have a CD changer now, the CD changer harness terminates at the driver front kick panel.

    The ground behind the seat is for...
  25. The bracket is the biggest thing you'll need plus...

    The bracket is the biggest thing you'll need plus the wiring. Keep in mind the trunk carpeting is different between CD changer and non CD changer equipped. You can make non CD changer carpeting fit,...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4
GMN Approved Links!


www.rockauto.com www.adtr.net