Going to replace my rear main seal in my 93 302 HO. It's not the valve covers, upper intake gaskets, or oil pan gasket, I made sure of it, and it's a fairly large leak, a drip every minute or two after it is run for 10 minutes or so.
Seems fairly straight forward, remove driveshaft, remove transmission (t5 in this case) Remove old seal, reassemble in reverse.
Any pointers or recommended brands? Was thinking the teflon fel-pro.
I've read a lot of people who have replaced them and had them leak a short time afterwards (mustang owners). That would not be ideal, especially considering the engine is sealed up pretty well.
t5 has some leaks coming from...somewhere, going to replace those seals as well since i'll have it out.
Seems fairly straight forward, remove driveshaft, remove transmission (t5 in this case) Remove old seal, reassemble in reverse.
Any pointers or recommended brands? Was thinking the teflon fel-pro.
I've read a lot of people who have replaced them and had them leak a short time afterwards (mustang owners). That would not be ideal, especially considering the engine is sealed up pretty well.
t5 has some leaks coming from...somewhere, going to replace those seals as well since i'll have it out.
Comment