Today I did a tune up.
The spark plugs I bought would not go in. This happened on each one. The new were Autolite iradium and Autolite double platinium. I bought 2 sets. I tried each type in different holes but no luck. I cleaned the old plugs and put them back in. They were also Autolite 764, apperently the cheap ones. They went back in easily. Started the car, it ran fine. They are 6 years old.
I then did an oil change.
Started the car, ran fine.
Then came back out 30 minutes later and when I started the car. The starter would not disengage. It kept spinning the engine even after the key was turned off and removed as well as the solenoid switch was unplugged.
The only time the starter would stop was when I disconnected the battery.
1990 Colony Park with a 90 GT motor and GT 40 heads.
Any ideas?
Thank you
Mike
The spark plugs I bought would not go in. This happened on each one. The new were Autolite iradium and Autolite double platinium. I bought 2 sets. I tried each type in different holes but no luck. I cleaned the old plugs and put them back in. They were also Autolite 764, apperently the cheap ones. They went back in easily. Started the car, it ran fine. They are 6 years old.
I then did an oil change.
Started the car, ran fine.
Then came back out 30 minutes later and when I started the car. The starter would not disengage. It kept spinning the engine even after the key was turned off and removed as well as the solenoid switch was unplugged.
The only time the starter would stop was when I disconnected the battery.
1990 Colony Park with a 90 GT motor and GT 40 heads.
Any ideas?
Thank you
Mike
Comment