PotM GrandMarq.NET - Panther Headquarters Forum Index PotM
GMN Chat Room GMN's STORE!! GMN's Gallery Please!!
Results 1 to 5 of 5

Thread: 89 Country Squire compressor clutch not getting power

  1. #1

    Default 89 Country Squire compressor clutch not getting power

    The clutch isnt engaging so I checked the plug and its not getting power. Fuse is good and the relay on drivers side fender was clicking so I replaced it but new one also clicks when ac is switched on. System is full of R12 and I dont know what to check next.

    It does not have auto climate control.

    Thanks
    Last edited by SVTDarin; 07-12-2019 at 09:01 AM.

  2. #2
    Beater gonna beat sly's Avatar
    Join Date
    Mar 2010
    Location
    Lewisville, TX
    Posts
    20,965

    Default

    If the relay clicks, the ECM is switching the AC off because it thinks the throttle is wide open. Check the TPS sensor. The relay should not click when installed unless the key is on and engine is not running. Then the ECM will disable the AC so as to not damage the compressor or it's clutch during engine start.

    Only two things are infinite, the universe and human stupidity, and I'm not sure about the former. -- Albert Einstein
    rides: 88 MGM (SOLD), 93 Vic, 2000 Crown Vic, 2003 Expedition
    Quote Originally Posted by gadget73
    ... and it should all work like magic and unicorns and stuff.
    Quote Originally Posted by dmccaig
    Overhead, some poor bastards are flying in airplanes.

  3. #3

    Default

    Quote Originally Posted by sly View Post
    If the relay clicks, the ECM is switching the AC off because it thinks the throttle is wide open. Check the TPS sensor.
    snip

    The car runs, drives, idles fine, how do I check the TPS sensor or what am I checking for?

  4. #4
    Member WagonMan's Avatar
    Join Date
    Sep 2004
    Location
    Bridgewater Ct.
    Posts
    450

    Default

    Did you try jumping the low pressure switch? WagonMan
    1990 Colony Park
    1970 HEMI Superbird

  5. #5
    I'm an air-conditioned gypsy gadget73's Avatar
    Join Date
    Jan 2005
    Posts
    37,613

    Default

    Voltmeter from black to green on the TPS. With the key on and the throttle closed, it should be near 1 volt. The voltage should smoothly increase to about 4.5 volts with the throttle full open. If you have more than about 1.2 volts with the throttle closed, the TPS is most likely bad. You'll probably need some paperclips to poke into the connector in order to check this.


    http://www.lincolnsonline.com/tech/00127.html

    86 Lincoln Town Car (Galactica).
    5.0 HO, CompCams XE258,Scorpion 1.72 roller rockers, 3.55 K code rear, tow package, BHPerformance ported E7 heads, Tmoss Explorer intake, 65mm throttle body, Hedman 1 5/8" headers, 2.5" dual exhaust, ASP underdrive pulley

    91 Lincoln Mark VII LSC SE, triple black (Timewarp) - poly front bushings, KYB struts and shocks, Holley SystemMax1 lower intake, SilverFox AOD valve body,

    1984 Lincoln Continental TurboDiesel - rolls coal

    Quote Originally Posted by phayzer5 View Post
    I drive a Lincoln. I can't be bothered to shift like the peasants and rabble rousers

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
GMN Approved Links!


www.rockauto.com www.adtr.net