Activity Stream

Nice job getting to the root of it. I’m surprised plugs would cause a misfire on decel due to the extremely low load the engine is under. I would...

White also means a lean mixture, which is what I'd be leaning towards and what I'd prefer. Perhaps there is some bit of crossfire going on, if...

Yeah the downshift could be the cause for that issue. My TV pressure is up from factory aswell. That issue was the least of my worries anyways. ...

Very nice car for the money Kishy and the quality of the work transcends any "pre-owned certified " car one could buy on a lot. Amazing job.

Excellent job! That car looks pretty immaculate to me.

My experience with the AOD leads it to be a bit clunky on decel around 15-20mph as it pulls out of locked third and into second. Especially true if...

Unfortunately, it is the folks we trust that disappoint us. You did ALL the right things, checked even things you thought were fine and narrowed down...

Sweet!!

Yeah I was thinking it was a misfire aswell, but it took me long enough to question the shop receipt that says I have new plugs. I have no idea how...

Did I not mention a misfire? Good job on NOT assuming anything and checking thew plugs and wires!!

Here's the problem with those plugs: The shop receipt from a couple years back says 8pcs of NGK UR45. Which those are NOT, those are some rusty old...

Here's how I'd suggest you surprise her: Take her out for her birthday in your car. Have a friend drive her gift to the restaurant while you and...

Those numbers sound good to me. The plugs look good too, how many kms/miles are on 'em? The ground electrode on #1 & #7 (possibly # 4 too, possibly...

Made some compromises on the detailing in order to actually get it done. Specifically, skipped the "polish" step, which was actually going to be...

Sounds kinda familiar, but it could also be a misfire. I did a compression test, cyls 1-7 are all right around 145-155 psi (10-10,5 bar) and I can't...

It could be. Another way to test would be to position each cylinder at TDC on the compression stroke and feed compressed air into the cylinder. If...