Hi Gents,
Don't know if this is the correct sub forum, but I just had an issue pop up on my 90 Town Car. It's stuck on heat. AC system is working as normal (compressor kicks on, lines and dryer are cold) but no cold air from the vents.
After digging around a bit, I started looking for the blend door actuator - found it way up in the dash and it is not moving when I slide the temperature lever on the dash. I am thinking this is either a bad blend door actuator(appears to be an electric motor) or maybe the inside temp sensor for the ATC? does anyone know how to test that sensor before I start to replace the BDA?
Or maybe there is something I'm not thinking of?
Thanks!
Don't know if this is the correct sub forum, but I just had an issue pop up on my 90 Town Car. It's stuck on heat. AC system is working as normal (compressor kicks on, lines and dryer are cold) but no cold air from the vents.
After digging around a bit, I started looking for the blend door actuator - found it way up in the dash and it is not moving when I slide the temperature lever on the dash. I am thinking this is either a bad blend door actuator(appears to be an electric motor) or maybe the inside temp sensor for the ATC? does anyone know how to test that sensor before I start to replace the BDA?
Or maybe there is something I'm not thinking of?
Thanks!
Comment