Announcement

Collapse
No announcement yet.

A/c still kinda wierd when on gas...

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    A/c still kinda wierd when on gas...

    i replaced the soup can and it still kinda goes to defrost and blow heat under a load i know i should check for more vacuum leaks where should i start thou... its not as bad as before but still happens
    sigpic
    1986 Crown Victoria 302 Cold Air,Mac Shorty headers, Full Dual Exhaust with Super Forty Flows, Wagon Suspension with a Full Sound System Replacement 1/4 time 17.486 @ 77.43mph

    #2
    thermal blower lockout and the check valve at the firewall would be my guesses.
    86 Lincoln Town Car (Galactica).
    5.0 HO, CompCams XE258,Scorpion 1.72 roller rockers, 3.55 K code rear, tow package, BHPerformance ported E7 heads, Tmoss Explorer intake, 65mm throttle body, Hedman 1 5/8" headers, 2.5" dual exhaust, ASP underdrive pulley

    91 Lincoln Mark VII LSC grandpa spec white and cranberry

    1984 Lincoln Continental TurboDiesel - rolls coal

    Originally posted by phayzer5
    I drive a Lincoln. I can't be bothered to shift like the peasants and rabble rousers

    Everything looks like voodoo if you don't understand how it works

    Comment


      #3
      where can i get a new one if its it and how do i tell its bad??
      sigpic
      1986 Crown Victoria 302 Cold Air,Mac Shorty headers, Full Dual Exhaust with Super Forty Flows, Wagon Suspension with a Full Sound System Replacement 1/4 time 17.486 @ 77.43mph

      Comment


        #4
        whats the check valve look like??
        sigpic
        1986 Crown Victoria 302 Cold Air,Mac Shorty headers, Full Dual Exhaust with Super Forty Flows, Wagon Suspension with a Full Sound System Replacement 1/4 time 17.486 @ 77.43mph

        Comment


          #5
          ok i took out and deleted thermal blower lockout... still happens and the check vavle is the thing right under it right with the copper tubbing... I took that off by acciedent when i deleted my smog equipment
          sigpic
          1986 Crown Victoria 302 Cold Air,Mac Shorty headers, Full Dual Exhaust with Super Forty Flows, Wagon Suspension with a Full Sound System Replacement 1/4 time 17.486 @ 77.43mph

          Comment


            #6
            no, not that check valve. When you deleted the TBL, did you seal up the lines properly? If they're not sealed, thats the problem.

            Info on the check valve, including how to test it:

            http://www.lincolnsonline.com/tech/00130.html
            86 Lincoln Town Car (Galactica).
            5.0 HO, CompCams XE258,Scorpion 1.72 roller rockers, 3.55 K code rear, tow package, BHPerformance ported E7 heads, Tmoss Explorer intake, 65mm throttle body, Hedman 1 5/8" headers, 2.5" dual exhaust, ASP underdrive pulley

            91 Lincoln Mark VII LSC grandpa spec white and cranberry

            1984 Lincoln Continental TurboDiesel - rolls coal

            Originally posted by phayzer5
            I drive a Lincoln. I can't be bothered to shift like the peasants and rabble rousers

            Everything looks like voodoo if you don't understand how it works

            Comment


              #7
              whats the proper way to seal them
              sigpic
              1986 Crown Victoria 302 Cold Air,Mac Shorty headers, Full Dual Exhaust with Super Forty Flows, Wagon Suspension with a Full Sound System Replacement 1/4 time 17.486 @ 77.43mph

              Comment


                #8
                I was just reading the that lincoln artical and it says cans with more than one port has check vavle built in the new one i have does could i possible make use of this if its correct
                sigpic
                1986 Crown Victoria 302 Cold Air,Mac Shorty headers, Full Dual Exhaust with Super Forty Flows, Wagon Suspension with a Full Sound System Replacement 1/4 time 17.486 @ 77.43mph

                Comment


                  #9
                  You just have to make sure they're sealed up completely. I've used snug fitting screws dipped in RTV to seal those up.

                  No idea if they have a check valve or not. Not sure how one would work, unless its got a dedicated vacuum source and vacuum load ports. I would just use the stock check valve, and plumb the hose to a port that has no check valve. Be sure the un-used ports are all capped off too.
                  86 Lincoln Town Car (Galactica).
                  5.0 HO, CompCams XE258,Scorpion 1.72 roller rockers, 3.55 K code rear, tow package, BHPerformance ported E7 heads, Tmoss Explorer intake, 65mm throttle body, Hedman 1 5/8" headers, 2.5" dual exhaust, ASP underdrive pulley

                  91 Lincoln Mark VII LSC grandpa spec white and cranberry

                  1984 Lincoln Continental TurboDiesel - rolls coal

                  Originally posted by phayzer5
                  I drive a Lincoln. I can't be bothered to shift like the peasants and rabble rousers

                  Everything looks like voodoo if you don't understand how it works

                  Comment

                  Working...
                  X